Nissan Motor (GB) Cube recall: Cube (Z12) Driver Airbag
For affected vehicles the Driver's Airbag module may have been incorrectly assembled during production. In this condition the driver’s airbag inflator module may detach from the steering wheel.
Every UK recall and safety alert for Nissan Motor (GB) products, with what's wrong, which models or batches are affected and what to do. Updated automatically. 14 listed.
For affected vehicles the Driver's Airbag module may have been incorrectly assembled during production. In this condition the driver’s airbag inflator module may detach from the steering wheel.
For affected vehicles an incorrect Emissions Label may have been installed . As a result the label does not accurately reflect the vehicle’s actual emissions.
For affected vehicles there is an issue involving the E power Battery Management system (BMS) where warnings and entering limp mode or loss of power cannot be ruled out. Vehicle will not return to…
For affected vehicles the lithium-ion battery controller (LBC) on some X-Trail (T33) vehicles may not properly maintain diagnostic robustness. It has been found that these ICs may misdiagnose abnormalities and as a result the…
For affected vehicles the AdBlue Dosing Module may not have been initialised during the production process. In this condition the AdBlue Dosing Module does not trigger AdBlue injection and therefore NOx emissions are not…
For affected vehicles the tyre size has been incorrectly configured in some of the control units. In this condition the calculation of the vehicle speed for display is made using incorrect data. As a…
For certain vehicles the end-stop breaking force of the accelerator pedal is lower than the intended technical specification. This may lead to a rupture of the accelerator pedal assembly if the pedal is pressed…
For affected vehicles there is concern that the left side headlamp beam may be out of alignment.
For affected vehicles it has been identified that there is potential for movement between the fuel pipe and its retaining clip within the engine bay this movement can potentially lead to wear on the…
For affected vehicles there is a risk of head contact with the rear door latch. Due to the sharp edges of the door latch there is a risk of injury when head contact occurs.
For affected vehicles the back door hinge pins may have been incorrectly assembled during production. In this condition the back door hinge pin may be missing.
For affected vehicles there is an issue involving the steering gear for where damage or cracking cannot be ruled out. The consequences are that loss of assistance or in some cases loss of control.
For affected vehicles due to a software concern the calculated and displayed battery state of charge may rapidly fluctuate.
On affected vehicles the front seat belt may have been accidentally damaged during the parts preparation for assembly.