All UK Cars, vans & lorries recalls and safety alerts, newest first, with the hazard, affected models and what to do next. 4,358 listed.
It has been determined that on certain C-Class (205) and E-Class (213) Cars with AMG performance seats the laser welding between the backrest rail and the backrest metal fitting of the driver or passenger…
On affected vehicles it has been determined that drivers airbags with potentially faulty gas generator housing material may have been installed in vehicles of model series 156 176 246 205 238 & 253. If…
Burrs in the inner hydraulic clutch actuator housing can damage the oil seal causing oil to leak and accumulate in the phase cap. The HEV warning light will be displayed on the dashboard.An electrical…
The starter motor heatshield may break off.
It has been determined that on V-Class and Vito models with rotating front seats (SA codes SB5/SB6) the front seats can loosen the wire fixings under the seats when being rotated. Should the wiring…
It has been determined that on Vito models with rotating front seats (SA codes SB5/SB6) the front seats can loosen the wire fixings under the seats when being rotated. Should the wiring harness be…
On the affected vehicles the tightening torques of the anti-theft wheel bolts may not be to the correct to specification.
The fault affects the fuel level sensor within the fuel tank.The distance between the sensor and an in-tank fuel line could be too small which could allow the sensor to contact the fuel line…
The fault affects the brake system in particular the brake calipers on the rear axle. Because of a faulty coating hydrogen gas (approximately 10 ml) could be created in the coating of the piston…
There is a possibility that an oil plug located on the side of the engine may not be properly tightened. An engine oil leak could occur that could lead to a certain amount of…
Subject vehicles are equipped with incorrect engine oil software leading to the oil temperature not being detected over a certain threshold. This could lead to the oil pan deformimg due to high engine oil…
Software of switch module incorrect specification
Due to improper sealing of parking brake caliper shaft boots water might penetrate inside and rust the shaft. As the result of continuous use the rust will erode into the internal caliper and the…
Due to inappropriate water proof structure of the front deck water can drop on the wiper link. The wiper link ball joint may corrode and cause excessive wear of the resin part of the…
On Passat vehicles of a limited production period the retaining spring of the head restraint guide may be faulty because of a production problem. Because of a faulty retaining spring in an accident the…
Spot welds on the front side wall that join the door frame with the hinge reinforcements behind it might not have been applied
On affected vehicles the possibility exists that there may be a software error in the tyre pressure monitoring system of some X-Class vehicles If the tyre pressure falls below the minimum level required the…
It has been determined that it is possible that the connectors for the transmission oil cooler lines were not pressed together in accordance with specifications. As a result the transmission oil cooler lines could…
There is a possibility the air bag inflator may rupture on activation. Hino has not received any reports of this occurring in its vehicles in global markets. The recall is being conducted as a…
Affected vehicles received a recall remedy in which the replacement inflator may have been installed in an incorrect orientation.This may prevent the front passenger air bag from inflating as intended during deployment as designed.
The seat backrests on the right side of the front seats in the c-class Coupe/Convertible and E-Class Coupe/Convertible may not fully lock.
On the subject vehicles the Takata Driver and Passenger airbag inflators may not operate as intended Injury may result due to incorrect deployment of the Airbag
The front seat back pad mould (seat back cushion) and side airbag (SAB) are fitted to the seat back frame. The SAB is fitted underneath the pad mould and the pad mould has been…
On the affected vehicles the crimping preventing lateral movement of the steering column bearing may not be correct to specification. This may result in noise and play in the steering. Ultimately it could lead…