All UK Cars, vans & lorries recalls and safety alerts, newest first, with the hazard, affected models and what to do next. 4,358 listed.
The propellant mixing ratio in the igniters of the front passenger airbag assembly may not meet specification. If the airbag is required and activated it might not deploy or not completely deploy. This could…
The connection fitting of the vacuum line to the brake booster is not to specification and my not be durable. If the connection fails the brake booster will no longer be supplied with vacuum.…
On vehicles with ABS/ESC the earth connection may be interrupted. This may cause failure of the ABS/ESC system
On vehicles with ABS/ESC the earth connection may be interrupted. This may cause failure of the ABS/ESC system.
The ball head connecting the brake pedal and the master brake cylinder the ball head might not be locked properly into the ball cage. If the driver accidentally pulls up the brake pedal the…
The tightness of one of the air conditioning compressor support mountings may not be correct to specification. This will result in an abnormal noise and possibility of the compressor becoming insecure
The tightness of one of the air conditioning compressor support mountings may not be correct to specification. This will result in an abnormal noise and possibility of the compressor becoming insecure
Insufficient tightening of the steering column coupling could lead to wear of the steering coupling during use. In case of excessive wear of the steering coupling the coupling eventually may not transfer the effort…
The pre-tensioner in the driver�s side third row passenger seat belt may not have been produced according to the correct specification In the event of a collision the pre tensioner and seat belt will…
The software for the Electronic Stability Program (ESP) is faulty. The fault could lead to a low residual pressure in the hydraulic system so the brakes are applied and gain heat. This increased heat…
The screw securing the steering wheel to the splines may be missing. This can lead to loss of directional control thereby increasing the risk of a collision.
The urea water injector mounting flange on the exhaust front pipe may fail and allow the urea water injector to separate from the front pipe. This situation could result in noncompliance with requirements prescribed…
In unusual situations the Active Electronic Braking System (AEBS) can misinterpret freeze frame data and cause the brakes to fully apply when not required. The driver does have time to cancel the braking activity.…
3rd row seat retaining bolts and 2nd row seat belt shoulder anchor retaining bolts may not be tightened to the correct specification
Contacts inside the electric power steering motor may not have been correctly formed. Failure of these contacts would cause the loss of power steering assistance.If this happens a warning lamp will illuminate
Due to a firmware error the vehicle's restraint control module will not recognise the passenger seat is occupied. In the event of an accident the passenger airbag will not deploy
The battery supply line for the engine electrical system may be incorrectly routed and could result in a short circuit. This will produce a thermal overload of the battery line and melting of the…
The subject vehicles are equipped with right front seat side airbags which may not deploy in a collision as intended.
The heated washer jets fitted to some Kuga vehicles may have jet heating elements that are not correctly sealed. There is a possibility that poor sealing could lead to corrosion due to water ingress…
It is possible a recess on the inside of the instrument panel was not machined correctly. The recess is the predetermined break point of the instrument panel when the front passenger airbag is activated.…
Securing nuts at one of the upper steering column attachments may be issing or loose. Also the universal joint cross screw joint in the upper steering column must be checked
On the affected vehicles the bonding of the front bumper trim may not conform to specification. Over time the bonding may allow the trim to detach
When trying to drive off uphill from a standstill the vehicle may roll backwards. This is because of a software problem in the CMU.
The nearside front passenger detection mat was not fitted during production of the seat. No alarm or warning lamp will warn the driver if the front passenger has not fastened the seatbelt.