All UK Cars, vans & lorries recalls and safety alerts, newest first, with the hazard, affected models and what to do next. 4,358 listed.
On certain vehicles the connection between the front axle suspension strut and the steering knuckle could loosen due to an insufficient preload force.
Possible inadequate front windscreen adhesion to the vehicle body.
The fuel supply line connector may crack.
It is possible that the rear knuckle fastening screw does not have the correct tightening torque
Certain climatic conditions may cause a chemical change to the airbag propellants�over time.�
Certain climatic conditions may cause a chemical change to the airbag propellants over time.
A nozzle inside the suction jet pump in the fuel tank might not have been installed or fixed inside the pump according to specifications.
The bolted connection of the brake line on the front right wheel housing may not have been correctly tightened during production.
Possible missing bearing bush in the area of the steering worm gear.
The bolts on the rear stabilizer bracket might become loose.�
Ignition coils may short circuit and fail.�
Some steering rack trial parts were reintroduced into the normal production process.
Nitrogen oxide emissions may not meet requirements.
When the outside temperature is below 3�C there is loss of the front windscreen wiper function when the vehicle stops at 0 mph.
Due to a production error the wiring harness for the crankshaft position sensor may not be secured correctly into position.
The seat fastening to the anchor plate is not correct to specification.�
Incorrect weights on the identification plate located on the rear door pillar on the passenger side which could results in non-conformity with Regulation (EU)( no. 19/2011) and have an impact in terms of road…
Emissions control component could degrade earlier than expected
Emissions control component could degrade earlier than expected
Emissions control component could degrade earlier than expected.
The A-pillar cover holder may not have been correctly fastened.
Thermal ageing of an inline fuse located on the front right spring strut dome.
The front passenger seats were manufactured without the Occupancy Detection Sensor system (ODS) installed.
The rear seat back may not be securely latched when returned to the upright position after folding.