Every UK recall and safety alert for BMW products, with what's wrong, which models or batches are affected and what to do. Updated automatically. 26 listed.
The safety recall relates to a PVC seam seal defect which may have occurred in the body area of the right real light housing. It is possible that seam sealant was not applied to…
BMW has decided to initiate the safety recall “Curtain Airbag” with regard to the BMW model NA5. On affected vehicles both curtain airbags (left and right) may not have been properly screwed according to…
BMW has decided to initiate the safety recall “Replace the Onboard Charger” with regards to the certain BMW NA5 models. On affected vehicles the onboard charger will be replaced. If there is a reduced…
The Safety Recall relates to the air-conditioning wiring harness located behind the dashboard. On the affected vehicles the wiring harness was fixed very close to a screw connection on the interior microfilter housing cover.…
The Safety Recall relates to the engine starter motor. The fault relates to the RSW22 starter RWT (reinforced water tightness). It was found that with RWT starters an increased abrasion of the magnetic contact…
Affected vehicles may be fitted with a drivers airbag which may deploy with too much explosive force causing sharp metal fragments to be released into the cabin. It has the potential to fatally or…
Affected vehicles are already included in Safety Recalls within the markets they have previously resided in. The vehicles may be fitted with a driver and/or passenger airbag/s which if deployed may do so with…
A quality check has revealed a potential issue with the steering gear software program which monitors the function of two sensors and compares the signals. In the vehicles concerned due to an error in…
A quality check has revealed that the affected G61 vehicles software does not reflect the associated CoC documentation.
For affected vehicles there is a concern involving water ingress and corrosion to the starter motor for where a short circuit cannot be ruled out. It is strongly recommended to park the vehicle outdoors…
On affected vehicles either one or both of the outer most rear seats may not have been manufactured correctly and the sensitivity sensor may be deformed. If the sensor is not functioning correctly there…
For affected vehicles local overheating may occur at the electrical contacts of the vehicle's engine starter motor. This may cause an increase in current flow resulting in local overheating or risk of thermal event.
On affected vehicles the screw connection on the B+ power distributor in the vehicle's boot may have not been properly tightened.
For vehicles fitted with a Takata front passenger airbag with a PSPI inflator these vehicles have previously received a like for like replacement front passenger airbag via a previous safety recall campaign.
On affected vehicles the front seat belts may have damage to the torsion bar caused during manufacture. The retention function of the seat belt may not perform as expected in the event of an…
On affected vehicles the outer headrests of the second row of seats may not have been manufactured correctly. In case of a collision or an accident they may not provide the necessary protection increasing…
For affected vehicles there is concern that a gap in the windshield urethane seal at the right A-pillar was created. Due to the gap water can ingress with possible water contamination of the glove…
On affected vehicles the battery module frame may have been manufactured using too much force. In conjunction with swelling force of the battery this could lead to failure and a possible thermal event within…
On affected vehicles the ground connection cable on the 48V power supply control unit may not have been torqued to the correct specification.
On affected vehicles the screw connection of the positive battery cable onto the starter generator may not have been performed to specification.
On affected vehicles the rear brake hoses may not have been crimped correctly during production.
On affected vehicles the 48v connection to the starter generator may not be secured to the correct specification.
Affected vehicles may have a B-Pillar which may have been produced using incorrect materials.
For certain vehicles there is an adaptation measure for the emissions control system.