Can-Am Ryker recall: The fuel pump impeller could swell and cause the fuel pump to stop working.
The fuel pump impeller could swell and cause the fuel pump to stop working.�
Is there a recall on your Can-Am? Check every DVSA safety recall for Can-Am vehicles (38 since 2009) by model and year, with what's wrong and the free fix. 22 listed.
Can-Am has had 38 safety recalls registered with the DVSA since 2009, covering roughly 12,075 vehicles in the UK. None has been issued in the last 12 months. The most recent, on 2 January 2024, was Can-Am Ryker recall: The fuel pump impeller could swell and cause the fuel pump to stop working. Below you'll find a full page for each Can-Am recall since 2016; the checker above searches the whole DVSA record.
| Model | Recalls | Latest | Vehicles affected |
|---|---|---|---|
| Can-Am Spyder | 12 | Mar 2023 | 4,284 |
| Can-Am Ryker | 7 | Jan 2024 | 5,243 |
| Can-Am Outlander | 4 | May 2021 | 891 |
| Can-Am Renegade | 4 | May 2021 | 503 |
| Can-Am Can-Am | 3 | Dec 2023 | 453 |
| Can-Am Traxter | 3 | Nov 2023 | 298 |
| Can-Am Commander | 3 | Apr 2016 | 79 |
| Can-Am Maverick | 2 | Nov 2023 | 132 |
| Can-Am DS450 | 2 | Nov 2010 | 125 |
| Can-Am Immi | 1 | Jul 2020 | 39 |
| Can-Am RT | 1 | Jun 2017 | 1 |
| Can-Am Defender | 1 | Dec 2016 | 9 |
| Can-Am Ski-Doo | 1 | Oct 2010 | 3 |
| Can-Am DS90 | 1 | Feb 2009 | 15 |
Counts group model variants together (for example every version of a model name), and the vehicle numbers are the manufacturer's own estimates.
A recall rarely covers every car of a model. It usually applies to a run of build dates or specific VINs, so a listing here means your model might be included. To be sure, put your registration into the DVSA vehicle recall checker or ask any franchised Can-Am dealer to check your VIN. If your vehicle is included, the repair is free, whatever its age and however many owners it has had.
The fuel pump impeller could swell and cause the fuel pump to stop working.�
The rear view mirror's lens may dislodge from the housing.
The Operator�s Guide �Maintenance Schedule� section contains incorrect information regarding driven clutch pulley maintenance intervals which may lead to clutch failure.
Some vehicles were assembled with a fuel hose assembly that may have internal damage which could lead to a fuel leak.�
Potential contamination or component friction in the brake light switch may cause the brake lights to stay illuminated even when the brake pedal is not pressed.
The rear-view mirror lenses may dislodge from the mirror housing
The position light and flasher electrical harnesses in the front fenders may be loose and rub on the tyre. Over time this could lead to a short circuit causing the engine to stall while…
The Handlebar Stem Bolt may break suddenly. This could cause a loss of steering control.
The front sprocket may be defective and may be subject to premature wear.
The stock CVT air intake may become completely obstructed when vehicles are equipped with a track kit and used in snow.
The front lower ball joint may not have been properly installed into the steering knuckle.
In some specific riding conditions a high heat could develop in the muffler causing the upper right hand vent grill to melt.
The front wheels assembly may not have been performed properly during the predelivery preparation.
Some 4-point harnesses sold as an accessory could have been manufactured with missing stitching at attachment points.
The brake pedal mount could break during an emergency stop and cause a total loss of braking capacity.
The wheel nuts may crack resulting in a reduced clamping force.
The fuel tank may build excessive pressure due to a blocked vent. This could cause fuel to spray on occupants or bystanders when opening the fuel cap potentially causing injury. Additionally if an ignition…
The DPS shaft may break causing a loss of steering control.
Due to an error in the manufacturing process the headlamp lens may not conform to specification.
It has been identified that an error in the gearbox software can result in the incorrect message being displayed on the machine's instrument cluster. The gearbox position maybe displayed as being in the P…
On affected vehicles the steering rack and pinion assembly may have been manufactured with an incorrect amount of grease. In some circumstances this situation may result in steering lock. The manufacturer advises not to…
Steering coupling splines may strip on rack and pinion assembly resulting in a loss of steering control.