Zenos E10 recall: Brake fluid may leak
Affected vehicles may have bleed screws fitted to the front calipers which do not comply with specifications.
All UK Cars, vans & lorries recalls and safety alerts, newest first, with the hazard, affected models and what to do next. 4,358 listed.
Affected vehicles may have bleed screws fitted to the front calipers which do not comply with specifications.
The brake fluid container may not have been inserted far enough into its mounts or was not secured correctly which can result in it detaching and a loss of brake fluid. The driver could…
In the event that the airbag is activated excessive internal pressure may cause the inflator body to rupture and metal fragments may pass through the cushion material causing injury to the vehicle occupants and…
The bonnet lock mechanism my seize and allow the bonnet to open whilst the vehicle is in motion causing a loss of vision.
The crack on air intake ducts could cause the engine rough idle lower the power and the engine stall. Engine may stall whilst driving. Possible safety hazard whilst driving in traffic
Certain circumstances can trigger the Occupant Detection System (ODS) to incorrectly detect a high rise in capacitance which deactivates the ODS and turns the passenger airbag off. This is signalled to the driver via…
The control for the adjustment of the tilt and rake of the steering column is in a position where it could be accidentally operated by the driver whilst the vehicle is in motion. This…
Due to poor connectivity the indicators and/or vehicle lights may turn off or blink
The Hand Brake Valve handle automatic locking function may not maintain the park position. The handle may remain in the lock only temporarily and flip back from the parking position into the driving position…
There is a possibility of intermittent loss of ignition. This is a result of fretting at a terminal on the ECU which is caused by movement of the ECU bracket and battery tray and…
If the bonnet is not shut correctly on the main bonnet catch and the bonnet then opens to the secondary catch the secondary bonnet catch is not strong enough to hold the bonnet in…
If an electrical short occurs in the supply to the rear oxygen sensor the senor will fail but the driver will not see an immediate warning. A MIL warning may display after continued driving…
Affected vehicles may have been built with an incorrect crimping of the turbocharger oil feed pipe connector. This may cause oil leakage which may lead to odours smoke oil specks on the floor or…
A tooling problem during manufacture could result in the cylinder head not being to specification. It is possible that the fuel rail could loosen and fuel leaks cannot be ruled out. The customer may…
A filter in the Vehicle Stability Assist / Anti lock braking modulator may break and foul one of the one-way check valves in the modulator. If the check valve does not operate correctly the…
Due to vibrations particles inside the airbag control unit may cause a short circuit. This may reset the control module illuminating the airbag warning lamp and prevent the airbag(s) from acting as intended during…
On affected vehicles the driver's air bag inflation device may not conform to specification. As a result may not deploy correctly during an impact.
On affected vehicles the driver's air bag inflation device may not conform to specification. As a result may not deploy correctly during an impact.
There is a possibility that a strut top mounting bearing could be damaged when a high load is applied to the strut such as when the vehicle is driven over a large bump. If…
Due to a deviation in the manufacturing process the retaining bolt for the right rear seal belt may not have been tightened to the correct specification. In the event of a collision the belt…
Fuel may leak from connections for the fuel tank breather and vent hoses on to the ground. Poor engine running may be experienced accompanied by the engine management warning light. The fuel on the…
The fuel injectors supply rail could develop a leak over a period of time leading to a drop in fuel pressure in the injector supply rail which can affect the operation of the stop…
The fuel injectors supply rail could develop a leak over a period of time leading to a drop in fuel pressure which can affect the operation of the stop start system. In some extreme…
Due to a misrouted fuel pipe a metal hose clip my chafe against a nylon fuel pipe and may cause a fuel leak