All UK Cars, vans & lorries recalls and safety alerts, newest first, with the hazard, affected models and what to do next. 4,358 listed.
The thread on the swivel pin of the track rod end might not be to specification. Therefore when the nut was tightened onto the thread the correct clamping force may not have been attained.…
The airbag system Occupant Restraint Control (ORC) module may experience a front airbag and/or seatbelt pre-tensioner inadvertent deployment. An inadvertent deployment while driving could distract the driver and cause a crash without warning.
The exhaust tailpipe variants K7D K7C and K7N can become loose. Variant K7D can fall away from the vehicle leading to a heightened risk of incident for other road users. Where an exhaust gas…
The connection of the carbon drive shaft to the engine/transmission flange may not be to specification. Warnings of the development of the concern are: there will be noise malfunctions in the transmission and in…
The door child locks may disengage without driver knowledge. Though the door remains close it is possible for the door to then be opened from the inside.
On affected vehicles the incorrect type of bolt may have been supplied during repair work involving the removal of the seat belt mount or belt reel.
A seat mounting may not conform to specifications. This may also impact on seat belt mountings and in the event of a collision the seat and/or belt may not act as intended.
The Automatic Emergency Brake System (AEBS) may in certain traffic situations activate itself
Water may penetrate into the Electronic Brake Control Module (EBCM) connector. In the worst case water can enter the EBCM where a short circuit may lead to a risk of fire. Warning before the…
An incorrectly manufactured crank position sensor may cause the engine to unexpectedly cut out or not to start.
Due to a nonconformity of production the driver's air bag may not deploy correctly and may not provide protection as intended.
The lower nut & bolt securing the front shock absorber to the steering knuckle on either side of the affected vehicles may not have been tightened to specification. The bolt may work loose causing…
A component of the steering column may not be to specification and could fail. If this occurs there would be a loss of directional control.
The engine may stop when braking from lower speeds right before the vehicle comes to a standstill. The concern might be interpreted by the driver as a planned engine stop as part of the…
A component of the steering column may not be to specification and could fail. If this occurs there would be a loss of directional control.
A component of the steering column may not be to specification and could fail. If this occurs there would be a loss of directional control.
The sunroof glass panel may not be correctly bonded to the sunroof sliding frame.
A threaded connection in the Prefuse box may not be tightened to the correct specification. This may excessive resistance and create a heat source. This could cause a fire. Additionally vibration may cause power…
An incorrectly manufactured crank position sensor may cause the engine to unexpectedly cut out or not to start.
Due to a nonconformity of production the driver's air bag may not deploy correctly and may not provide protection as intended.
The door child locks may disengage without driver knowledge. Though the door remains close it is possible for the door to then be opened from the inside.
On retrofit Low Entry Cab the steering limiter valve does not offload the system pressure correctly. This may cause high stress/forces on the link rod adjusting sleeve and ball joint which could lead to…
An abnormal noise may occur at the steering gear box when moving the steering wheel to right or left due to pinion plug nut loosening. If the concern is not resolved the pinion could…
The rear calipers may not have been manufacturer to design specifications. as a result the seals may allow brake fluid to leak. This may affect brake efficiency but the brake fluid level warning light…