Land Rover Range Rover Evoque, Range Rover Velar, Discovery Sport recall: AJ21-D4 Turbo Oil Feed Pipe Leak
Affected vehicles have a Turbocharger oil feed pipe that may over time loosen and lead to an oil leak
Every UK recall and safety alert for Land Rover products, with what's wrong, which models or batches are affected and what to do. Updated automatically. 56 listed.
Affected vehicles have a Turbocharger oil feed pipe that may over time loosen and lead to an oil leak
On affected vehicles the incorrect specification of plastic was used to manufacture the oil filter housing. This housing may over time and with vehicle use crack. This could result in oil under pressure leaking…
On affected vehicles converted by JLR Classic Works the brake pipes may have been incorrectly assembled to the brake modulator.
For the affected vehicle a concern has been identified where the there is an inadequate depth of weld (penetration) between the busbar and the anode in the module of the Plug-in Hybrid Electric Vehicle…
A concern has been identified where the clamps used to secure the fuel injectors into the cylinder head on certain AJ20-D6 engines may crack allowing the injector to come loose. This loose injector could…
On affected vehicles the right-hand tailgate and body mounted rear lamps may experience water ingress leading to one or more lamp failures.
For affected vehicles the manufacturer has developed a software enhancement to further increase vehicle security.
For affected vehicles the manufacturer has developed a software enhancement to further increase vehicle security.
Affected vehicles may have a right-hand side lower A Pillar bolt that may not have been tightened to the correct torque. In the event of a crash the body structure may be impaired increasing…
On affected vehicles there is concern that the structural adhesive applied to the bodyshell has been mis-applied.
On affected Range Rover vehicles fitted with V8 Gasoline NC11 engines the fixings used to secure the engine mounted oil cooler hoses have been found to have inadequate thread engagement.
On affected Plug-in Hybrid Electric Vehicles (PHEV) it is possible that the internal combustion engine will not start when required. This may occur whilst the vehicle is in motion and the vehicle will operate…
Front axle casing may fail causing the suspension to collapse.
For certain vehicles the bolt connecting the busbar to the traction battery module connector has not achieved the required clamp force. Arcing at the joint and excessive heat generation cannot be ruled out with…
On certain 2014 - 2016 Model Year Land Rover Range Rover vehicles the front suspension upper knuckle joint could develop a crack. In extreme cases where a crack in the front suspension knuckle has…
On affected 2022 - 2023 Model Year Land Rover Range Rover vehicles the external rear lamp mounted in the body could partially or permanently fail to operate resulting in one or more of the…
On affected vehicles the second row 60% seat frame may have a latch installed with a defective weld. In vehicles that have a defective weld on the second row 60% seat frame latch the…
On affected vehicles there is an issue involving the seat latch in the area of the third row of seats for where injury in the event of an incident cannot be ruled out.
For certain 2023 Model Year 3.0L AJ20-P6 Land Rover Range Rover Range Rover Sport Range Rover Velar Discovery and Defender vehicles a small number of engines the cam carrier oil gallery hasn�t been fully…
On affected vehicles there is a risk where the water pump pully drive belt can become damaged leading to detachment or destruction. Where water pump pully drive is lost this leads to a loss…
On certain Classic Defender Works V8 70th Edition (90 Derivative) vehicles the front anti-roll bar diameter is too small and is the wrong specification for the vehicle application.
On certain vehicles the left-hand headlamp aim has been set incorrectly.
Some of the hot end exhaust bracket fixings may not have been fastened or not have been fastened to the required torque.
Damaged front seat belt pretensioner tube may have been installed on the seat belt retractor.