MG MG5EV EXCLUSIVE recall: Vehicle roof bars were previously recorded as being non-load bearing
Vehicle roof bars were previously recorded as being non-load bearing.
All UK Cars, vans & lorries recalls and safety alerts, newest first, with the hazard, affected models and what to do next. 4,358 listed.
Vehicle roof bars were previously recorded as being non-load bearing.
The current software does not provide sufficient NOx monitoring to confirm that the legal requirements on NOx emissions are met.
There is a risk that the Brake Pedal may fall down while driving resulting in the total loss of brake performance.
The behaviour of the emergency call system might not meet specifications.
The breather pipe may not be properly welded to the fuel tank.
The bolt connection of the steering�propshaft�to the steering gear may�not be tightened correctly in�production�or the hex socket fit bolt may be missing.
The behaviour of the emergency call system might not meet specifications.
Error in emission control readings.
The behaviour of the emergency call system might not meet specifications.
The behaviour of the emergency call system might not meet specifications.
A friction weld seam has been over torqued at the manufacturer of the steering propshaft and incorrect guide rings installed.
The connection of the gas lines of the inertisation system might not meet specifications.
Vehicles could be equipped with a front axle brake caliper carrier which could have been manufactured outside the specifications.
The after treatment injector pipe may crack and leak.
The corrosion protection of the high-voltage battery housing may not be sufficient.
The behaviour of the emergency call system might not meet specifications.
The behaviour of the emergency call system might not meet specifications.
The behaviour of the emergency call system might not meet specifications.
The behaviour of the emergency call system might not meet specifications.
The behaviour of the emergency call system might not meet specifications.
The behaviour of the emergency call system might not meet specifications.
A possibility that lock nuts were installed on the rear axle trailing arms that were not manufactured according to the required parameter field.
The screw connection of the power supply on the starter motor might not have been installed according to specifications.
Possible incorrect or missing cotter pin on steered axle joint.