Piaggio MEDLEY 125 recall: Frame may crack
The frame of the machine may develop a crack. Should a crack develop as it gradually develops the steering and handling will get progressively worse. If not repaired the frame could beak rendering the…
All UK Motorcycles recalls and safety alerts, newest first, with the hazard, affected models and what to do next. 337 listed.
The frame of the machine may develop a crack. Should a crack develop as it gradually develops the steering and handling will get progressively worse. If not repaired the frame could beak rendering the…
The Combined Braking valve has a rubber washer fitted to a threaded fitment. The rubber washer isn�t suitable for the purpose and has shown signs of allowing hydraulic fluid to pass. If the seal…
Vibrations can cause the tail / brake light bulb socket to displace and come away from the lamp assembly.
Brake caliper assembly may be incomplete on the models referred to above due to deviations in manufacturing at our supplier. The anti-rattle plates and cotters may be missing. This may lead to problems on…
One or more of the front brake disc retaining screws may loosen. This may be identified by rattling and may affect the brake's efficiency. In extreme instances the brake disc could detach.
The hazard warning lamps wiring may not be of the correct length and can become damaged during steering operations. This may cause the hazard lamps not to work but will not affect the individual…
The fixed fork tube can suffer preliminary damage due to unusual incidents with momentary high stress without the user noticing the damage. Through longer usage with high stress the pressed in seal plug can…
An oil line may not have been correctly clamped which may allow oil to leak.
Under certain conditions the headlight control unit may reboot which can affect the headlight operation
There is a possibility of interference and fretting between the ABS brake pipes and the secondary air system connection which over a period of time could in the most extreme cases lead to loss…
Due to a non-compliance in the surface treatment on the fork tubes cracks may appear. This may lead to breakage of the fork tube
Due to a software issue some motocross machines may stall under certain conditions.
If the machine is intensively used off road there is a potential for the shock-end eyelet on the rear shock absorber to fail.
The front brake caliper might not be fully secure. As a consequence of this the brake caliper can get loose and in the worst case the brake could be lost.
The lower handlebar holder may have been manufactured with improper painting instruction and thread locking agent may not have been adequately applied to the stud bolt thread of the lower handlebar holder. Due to…
The propellant used in the subject air bag inflators may degrade over time due to heat cycles and exposure to moisture. In the event that the airbag is activated it may overinflate due to…
A fuel leak could occur at the retaining nut for the fuel sensor on the fuel tank which in adverse circumstances can lead to a potential fire risk. The loss of fuel from the…
The rear brake hose could be incorrectly routed and chafe against other components. This condition could lead to the brake hose leaking fluid and the loss of performance at the rear brake.
The drive chain connecting link is not manufactured to specification which can lead to premature failure of the connecting link possible consequential damage and loss of drive.
It has been identified that the dimensions of the fitting bracket which secures the fuel tank to the frame are incorrect and this can cause the bracket to contact the fuel tank. This may…
It has been identified that water/moisture can enter the Sub-Switch Assembly and contaminate the main switch circuit board. This can possibly cause corrosion of the main switch electric terminal. In the worst case this…
It has been identified that a fuel hose may not have been produced to specification. This can cause a fuel leak which is not rectified could in the worst case scenario result in a…
The waterproof boots for the throttle cable may not be manufactured to specification. The boots may deteriorate and allow water ingress. The water could freeze in low ambient temperatures causing the throttle not to…
On some units there is a possibility that the brake pedal has incorrect welding penetration between the arm and the foot support. In this condition the brake pedal may break when a breaking force…