All UK Cars, vans & lorries recalls and safety alerts, newest first, with the hazard, affected models and what to do next. 4,358 listed.
It has been identified that due to the non-conforming layout of the airbag wiring and missing cut-proof protection the airbag wiring may interfere with the steering wheel wiring terminal. This can cause the abrasion…
The front impact sensor wire(s) may become detached during a crash event before the �impact signal� is recorded by the Occupant Restraint Controller (ORC). This may affect deployment of airbags and/or operation of pretensioners.
Affected vehicles may experience a lack of braking control on the rear axle when reverse gear is engaged.
The electrical contact of the Electronic Control Unit (ECU) of the Electric Power Steering (EPS) is not sufficiently robust over the service life of the vehicle. As a result the power steering support may…
It has been identified that due to an internal defect within the drivers air-bag if the SRS system detects an impact/collision which requires deployment of the air-bags then the drivers air-bag may not deploy.…
It has been identified that due to a manufacturing issue the Anti-lock Braking System (ABS) Actuator Control Unit may have contamination within it. When in use the contamination particle can migrate within the ABS…
It has been identified that the rear seatbelt extender may not retract as intended due to an issue with the individual friction conditions experienced by the belt extender which have not be programmed into…
On certain 6 and 8 cylinder engine vehicles a faulty rear engine compartment panel/bulkhead may have been installed. It is therefore possible that the panel/bulkhead may contact the left exhaust catalytic converter due to…
It has been identified on the CLA Shooting Brake models with load compartment package the rear seat back-rest retaining bracket threaded connection may not have been manufactured to the correct specification. If the vehicle…
The rear axle bolts may not have been correctly tightened which may generate a noise from inside the wheel arch or cause friction on the Tyre. If the concern is not addressed it is…
One of the rear axle bolts retaining the stub axle carrier on the left and/or right side may not have been correctly tightened.This could allow the stub axle to separate from it's mounting.
It has been identified that the bonding on the glass panel of the rear left upper maintenance flap may not be to specification. This may allow the glass to vibrate and can result in…
The rear seat buckle nuts may not be fully secure. In this condition the seat belt buckle may make a rattle noise. In an extreme case the nut may come off and the rear…
Some vehicles may have an incorrectly assembled front seat belt with the right hand seat belt fitted on the left hand side or vice versa. This could cause the seat belt upper anchorage to…
It has been identified that due to corrosion the engine hatch switches may become stuck in closed or compressed position. This will indicate that the hatch is closed regardless of whether the hatch is…
It has been identified that the incorrect mounting bracket for the power assisted steering pump may have been installed. This can cause misalignment of the pump and cause wear to the drive mechanism. This…
It has been identified that the durability of the lower trailing arm cannot be guaranteed. The arm can start to crack or fracture which if used on race track use or similar events can…
It has been identified that the striker wire on the bonnet lining may not have sufficient support to prove it with the security for its intended purpose. This can lead to incorrect locking of…
The Soft Ware applied during manufacture was incorrect for Medium Duty Engines. All heat temperature sensors are affected and are not functioning. The Heat Sensor function is lost and there is no warning to…
It has been identified that certain internal body joints or fixing may not have been torqued to the correct specification. If not torqued to the correct specification then the joints/fixings may loosen over time.…
Due to exposure of water and dirt intrusion in the engine compartment the alternators may fail prematurely due to seized bearings. In the worst case the alternators could overheat causing an engine compartment fire.
It has been identified that the driver can inadvertently circumvent the correct operating procedure for the closing/opening of the rear plug and slide door. If the door operating sequence has been overridden then when…
It has been identified that the bonnet striker support may corrode. If this corrosion is not treated there is a possibility the bonnet striker support may fail which will allow the bonnet to open…
It has been identified that the locking nut of the differential pinion may not have been tightened to the correct specification. This will be identified to the driver by noise generated from the differential…