Westfield Mountney Steering Wheel recall: Steering wheel rivet change from aluminium to steel
Incorrect specification of steering wheel rivets.
All UK Vehicle parts & accessories recalls and safety alerts, newest first, with the hazard, affected models and what to do next. 79 listed.
Incorrect specification of steering wheel rivets.
Incorrect heat treatment of shock absorber bolt.
Brake pads supplied with incorrect friction material.
Brake pad friction material detachment from backplate.
When towing a trailer the lights and/or the LED module mail fail due to incorrect contact between the towing harness and the trailer coupling.
Brake drum DRM9926 for Vauxhall Corsa (BATCH CODE 181116C) The circlip that holds the bearing in may not be inserted correctly this would allow the bearing to become loose. This could allow the wheel…
The fuel cap seal effectiveness may be compromised by the flap retention spring and fuel may leak in the event of a vehicle rolling over.
A small batch of wishbones may have been manufactured with out a ball joint secondary securing clip. This may allow the ball joint to dislocate from its location. The ball joint is unlikely to…
The sealing arrangement within the filler neck may be distorted and allow fuel to leak. This may be noticeable as wetting or a small volume within the dust cap. It is more likely to…
The clip-on handlebar is susceptible to Stress Corrosion Cracking. This can cause the part to fail during use and could affect control of the machine. The manufacturer recommends to immediately STOP using the clip-ons
The half shaft retaining bolt holes in the rear disc may have an incorrect thread. Retaining bolts may fit but may become loose and fall out. This would allow the half shaft and wheel/hub…
Due to an in the fitting process replacement screens may not have been correctly fitted. Drivers may notice water ingress and/or wind noise
When charging the battery externally from the vehicle there is a possibility that the earth provision for some sides of charger enclosure may not function. This is due to the anodising and bonding of…
The printed circuit in the power supply unit may overheat.
Due to contamination during the production process the fuel filter may leak.
Damage to the tyre structure could have occurred during the mounting of the tyre to the wheel. This can lead to severe tyre sidewall deformation and rapid deflation.
It has been identified that due to a production issue there is the potential for the brake shoe web ends where they are located at the cam roller D slots to either break orfail…
It has been established that the welding on the foot bracket of the shock absorber is not to specification. This can result in the failure/detachment of the foot bracket which could cause loss of…
Over time corrosion of the internal circuit board can lead to unpredictable functionality of the alarm. This can cause the alarm to operate and in the most severe cases may cause the motorcycle not…
Seatcovers have been supplied which may affect deployment of the combined side/curtain airbags.
It has been identified that the roof vent/hood may have been fitted with the incorrect screws around the hinge area. In additions some vents/hoods may not have been glued correctly. These issues could result…
The fuel filter may leak at fuel system working pressure from the top cover. This is due to a none conformance during the manufacture of the filter.
The Hand Brake Valve handle automatic locking function may not maintain the park position. The handle may remain in the lock only temporarily and flip back from the parking position into the driving position…
Under certain circumstances a dimensional error on the subject aftermarket front brake levers may cause the brake lever blade to contact the handlebar grip before maximum brake performance is achieved. This condition if present…