Every new product, food, vehicle, medicine and pet recall in the UK, newest first. Checked against official sources every 15 minutes. 10,759 listed.
An electrical overload event in the 48Volt (V) electrical system may cause a failure of the Metal Oxide Semiconductor Field Effect Transistor.
The headlight adjustment might not meet the specification
Certain specific calibrations of functions must be changed in the engine management of the vehicles
Milk
Mylan UK Healthcare Ltd is recalling remaining stock of certain batches as a precautionary measure after a product sterility non-compliance event which occurred during a recent inspection at the contract manufacturing site.
The front axle support (subframe) welding process has not been completed according to specifications.
Vehicle rear wheel hub bolts may not be tightened according to specification and/or the incorrect wheel hub may be installed
This product may contain mould. Mould does not usually cause food poisoning, however, the FSA would advise against consuming visibly mouldy foods because the presence of mould might make the food unsafe.
medac Pharma LLP is recalling a specific batch of products due to some inspected vials showing hairline damage to the shoulder of the vials.
The presence of plastic makes this product unsafe to eat.
Intrapharm Laboratories Ltd has informed us that there is a difference in dosage instructions between the carton and label. The Patient Information Leaflet (PIL) and bottle label contain the correct instructions.
Milk
The electronic control unit (ECU) doesn�t control the sudden increase in engine rpm if the transmission gear is not properly engaged
Milk, almonds (nuts), hazelnuts (nuts), peanuts, soya and wheat (gluten)
Gradual overheat degradation of the vehicle charge sockets.
Possible crack in the rear axle knuckle casting.
It may be possible that the ball type tow-bar does not meet the requirements of the fatigue strength.
There is a possible risk of the ignition switch not disengaging correctly after starting the vehicle resulting in the key jamming in the start position. In rare circumstances this may cause a thermal incident.
The welded joint on the park lock actuator plate may be of poor quality and has the potential to fail during usage.
The front frame suspension arm anchor bolt torque could be insufficient.
P-Clip holding the Starter Motor cable may chafe through the outer insulation of the cable and cause a possible short circuit.
Tin plating on the bulk capacitor terminals may create a short circuit
It may be possible that the ball type tow-bar does not meet the requirements of the fatigue strength.
Drivers airbag may not deploy correctly