Hyundai Ioniq recall: Wheel nuts not tightened to correct specification
Wheel nuts not tightened to the correct specification
Car, van, motorbike and caravan safety recalls from the DVSA. 4,885 listed.
Wheel nuts not tightened to the correct specification
A condenser may fail because of inadequate heat treatment in the airbag control unit.
Premature degradation of emission control component.
Potential for a thermal overload of auxiliary switchboard
A deviation in the production process may have led to a blowhole in the area of the front left suspension mounting point
Possible failure of flexible air brake hose to the front axle.
The front passenger seatbelt may not retain the passenger sufficiently in case of an accident with high impact.
The passenger outer seat belts may not be correct to specification
The passenger outer seat belts may not be correct to specification
Steering columns were produced not according to specification.
A condenser may fail because of inadequate heat treatment in the airbag control unit.
The Quick shifter Assembly TSA body may come into contact with the gear change linkage.
Improper tightening of the fuel pipe may lead to leakage and engine stall.
Steering columns were produced not according to specification
Possible non-conformity of the zinc plating surface of the brake hose terminals
The Trike may respond incorrectly to a faulty rear WSS (Wheel Speed Sensor) signal.
Front passenger airbag cushion may not have been sewn correctly
Possible bolt failure in the Spacer.
Possible bolt failure in the Spacer
Possible bolt failure in the Spacer.
Possible bolt failure in the Spacer
Possible bolt failure in the Spacer
NOx sensor was not correctly tightened during manufacture on the production line
Emission values may be higher than expected.