Car, van, motorbike and caravan safety recalls from the DVSA. 4,885 listed.
The electrical switch of the steering lock may not conform to specification. This could cause the intermittent unwanted switching off of information displays on the instrument panel.
The electrical switch of the steering lock may not conform to specification. This could cause the intermittent unwanted switching off of information displays on the instrument panel.
The wiring harness under the fuel tank may be damaged from contact with the frame edge. This can lead to a short circuit and the engine stalling. In addition on all 2011-2012 models and…
The side curtain air bags for both left and right sides of the vehicle may not have been produced to specification. It is possible for the side curtain air bag may not position itself…
A brake pipe in the engine compartment may have been incorrectly positioned and could foul the engine. In extreme cases the pipe may fail and allow brake fluid to leak.
Incorrect software may have been installed during manufacture. This may cause erratic idling when coming to a halt and the engine may shut down. Consequently the auto start/stop may not operate as intended.
The excess length of the wiring harness to the engine control unit could result in a faulty camshaft signal. This faulty camshaft signal may lead to an unintentional cancellation of the automatic starting procedure…
On affected vehicles the drive to brake vacuum pump may fail. This may cause a loss of brake servo assistance and a hard brake pedal. It may also cause a reduction in engine power.
Internal cluctch pistons may have been incorrectly manufacturerd. This may cause incorrect transmission operation.
The high-voltage battery charger may not have been produced to specification which could lead to an incorrect detection of an external charging cable. This in turn can lead the request for �P� to be…
On affected vehicles the bolts retaining wall mounted seat belts and grab handles may not conform to specifications. These bolts could become loose and affect the security of the seat belt and grab handle.
A manufacturing defect of a component within any of the four door locks could result in jamming of the internal mechanism which prevents the closing of any of the vehicle's doors or risk unexpected…
A manufacturing defect of a component within any of the four door locks could result in jamming of the internal mechanism which prevents the closing of any of the vehicle's doors or risk unexpected…