Mercedes-Benz S-class recall: The communication module might not meet specifications
On certain vehicles the communication module might not meet specifications.
Car, van, motorbike and caravan safety recalls from the DVSA. 3,839 listed.
On certain vehicles the communication module might not meet specifications.
A battery may have an incorrectly positioned/welded busbar in one of the battery arrays
A potential for an intermittent internal connection issue on the DC/DC chip of the on-board charger.
The rear window heater cable may become damaged due to insufficient fixation design
There is an error in the specific software calibrations of the Engine Control Unit.
Following a previous campaign the toe and/or camber values on the rear axle may in certain circumstances incorrectly be changed without this being noticed.
On certain vehicles the software of the engine control unit might not meet specifications.
Due to a nonconformity in production the side marker lights are not functioning.
Vehicles may have an incorrect tightening torque on several rear axle component fixings.
Vehicles may have an incorrect tightening torque on several rear axle component fixings.
In the cooling system of the engine the radiator cap may have insufficient sealant performance due to small overlap allowance with the filler neck.
Leaf spring may break during operation of the vehicle.
Vehicle may not meet standard ECE R55 where a towing hook must also have an attachment for the safety wire.
The steel frame supporting the hydrogen gas tanks in the �engine bay� of the vehicle may show signs of fatigue at some of the welded joints leading in some cases to the failure of…
The accelerator function may not operate as intended when fully released.
It is possible for the rear suspension spring to become detached from the lower locating cup.
When the internal temperature of the instrument module (IM) is below 0 �C the IM display may generate an error message and then shortly after go blank until the next ignition cycle when the…
The rear window electrical harness could become displaced from its original position and present a potential thermal issue.
The rear window electrical harness could become displaced from its original position and present a potential thermal issue.
On certain vehicles the power supply connection of the electric power steering might have been contaminated with melted adhesive.
Crash pads may not have been installed on the high-voltage battery during vehicle assembly.
Due to a production nonconformity there may be the possibility of a fuel leak from the fuel pressure and temperature sensor.
Inadequate front windshield adhesion to the vehicle body structure.
The fuel heater may fail due to a cable damaged by heat at the electrical connection of the fuel filter heater.