Car, van, motorbike and caravan safety recalls from the DVSA. 4,559 listed.
The affected vehicles may be equipped with a crankshaft sensor with a software fault. The crankshaft sensor cannot process the signal values from the crankshaft transmitter due to an improper firmware level. The firmware…
The propshaft may fail and fall of the vehicle causing injury and damage to other road users.
Pneumatic door sensitive edge not operating when powered down
In 2013 Nissan announced a Recall campaign to replace Takata SPI front passenger airbag inflators. A non-dessicated passenger airbag inflator was used for the replacement. Although there have been no known incidents associated with…
The rear seat back lock strikers may be missing on both sides of the seat which could cause the backrest not to remain in the upright position.
Panoramic glass sunroof the front panel and rear fixed section may not be bonded correctly
It has been determined that on certain C-Class (205) and E-Class (213) Cars with AMG performance seats the laser welding between the backrest rail and the backrest metal fitting of the driver or passenger…
On affected vehicles it has been determined that drivers airbags with potentially faulty gas generator housing material may have been installed in vehicles of model series 156 176 246 205 238 & 253. If…
Burrs in the inner hydraulic clutch actuator housing can damage the oil seal causing oil to leak and accumulate in the phase cap. The HEV warning light will be displayed on the dashboard.An electrical…
The starter motor heatshield may break off.
It has been determined that on V-Class and Vito models with rotating front seats (SA codes SB5/SB6) the front seats can loosen the wire fixings under the seats when being rotated. Should the wiring…
It has been determined that on Vito models with rotating front seats (SA codes SB5/SB6) the front seats can loosen the wire fixings under the seats when being rotated. Should the wiring harness be…
On the affected vehicles the tightening torques of the anti-theft wheel bolts may not be to the correct to specification.
The fault affects the fuel level sensor within the fuel tank.The distance between the sensor and an in-tank fuel line could be too small which could allow the sensor to contact the fuel line…
The fault affects the brake system in particular the brake calipers on the rear axle. Because of a faulty coating hydrogen gas (approximately 10 ml) could be created in the coating of the piston…
There is a possibility that an oil plug located on the side of the engine may not be properly tightened. An engine oil leak could occur that could lead to a certain amount of…
Subject vehicles are equipped with incorrect engine oil software leading to the oil temperature not being detected over a certain threshold. This could lead to the oil pan deformimg due to high engine oil…
Software of switch module incorrect specification
Due to improper sealing of parking brake caliper shaft boots water might penetrate inside and rust the shaft. As the result of continuous use the rust will erode into the internal caliper and the…
Due to inappropriate water proof structure of the front deck water can drop on the wiper link. The wiper link ball joint may corrode and cause excessive wear of the resin part of the…
On Passat vehicles of a limited production period the retaining spring of the head restraint guide may be faulty because of a production problem. Because of a faulty retaining spring in an accident the…
Spot welds on the front side wall that join the door frame with the hinge reinforcements behind it might not have been applied
On affected vehicles the possibility exists that there may be a software error in the tyre pressure monitoring system of some X-Class vehicles If the tyre pressure falls below the minimum level required the…
Brake pad friction material detachment from backplate.