Peugeot recall: The filtering performance of the diesel particulate filter may not meet the required specification
The filtering performance of the Diesel Particle Filter (DPF) may not meet the required specification.
Car, van, motorbike and caravan safety recalls from the DVSA. 4,885 listed.
The filtering performance of the Diesel Particle Filter (DPF) may not meet the required specification.
Vehicle rear wheel hub bolts may not be tightened according to specification and/or the incorrect wheel hub may be installed
The front axle support (subframe) welding process has not been completed according to specifications.
The electronic control unit (ECU) doesn�t control the sudden increase in engine rpm if the transmission gear is not properly engaged
It may be possible that the ball type tow-bar does not meet the requirements of the fatigue strength.
Possible crack in the rear axle knuckle casting.
Gradual overheat degradation of the vehicle charge sockets.
There is a possible risk of the ignition switch not disengaging correctly after starting the vehicle resulting in the key jamming in the start position. In rare circumstances this may cause a thermal incident.
The welded joint on the park lock actuator plate may be of poor quality and has the potential to fail during usage.
Drivers airbag may not deploy correctly
It may be possible that the ball type tow-bar does not meet the requirements of the fatigue strength.
Tin plating on the bulk capacitor terminals may create a short circuit
P-Clip holding the Starter Motor cable may chafe through the outer insulation of the cable and cause a possible short circuit.
The front frame suspension arm anchor bolt torque could be insufficient.
Insufficient clearance between transmission harness and catalytic convertor.
A rear seat longitudinal adjustment lever may not lock properly.
A rear seat longitudinal adjustment lever may not lock properly.
The front hub assembly fixing on to the front suspension damper may not be correct to specification.
The front hub assembly fixing on to the front suspension damper may not be correct to specification.
An electrical contacting inside the engine control unit might not meet the specification
A curtain airbag which cannot be guaranteed to provide the intended protection in the event of an accident.
A fuel pump flange assembly that when exposed to certain chemicals may degrade over time.
The seat frame may not have been bolted correctly to the seat rail on the driver and/or front passenger side
The absorption of moisture into the driver�s airbag propellant could lead to slow deployment or inflator rupture.