Car, van, motorbike and caravan safety recalls from the DVSA. 3,959 listed.
Improved locking split pins for the brake pad holding brackets in the front and rear brake calipers are available
The oil filter line may come into contact with the brake line.
A reduction in brake performance may occur whilst in a towing operation and under high load.
The polycarbonate panel located between the windshield and the panoramic sunroof may not have been bonded correctly during a prior service repair.
The bolting of the 48V wiring harness on a body-sided support point might not meet specifications.
The locking mechanism for the electrical connector of the side crash sensors might not meet specifications.
The steering column shaft assembly may detach from the bottom double joint.
The driver's airbag may have a chemical change to its propellant over time.
The driver's airbag may have a chemical change to its propellant over time.
The ABS Modulator plugs could potentially have been plugged into the wrong modulator.
The possibility that the engine timing belt may wear out prematurely.
The front seat track end stop bracket may become deformed.
Indirect tyre pressure monitoring systems may not comply with European regulations.
Static electricity may accumulate in the fuel filler tube.
There may be a loss of power and the message �Safely stop vehicle� may appear.
The engine may lose its ability to synchronize injector pulses and camshaft timing.
There is a possibility that the fuel injector fuel return line connection/s may not be fully secured.
The wheel centring bushes (Centre locks) may become loose.
The pre-crash brake assist function can be delayed.
The fault involves the tandem vacuum/oil pump fitted to the engine. On affected vehicles it is possible that the engine rotates in the opposite direction than it is meant to on start-up causing the…
One or more of the rear-wheel speed sensors may experience an electrical failure.
The oil pressure relief valve may fail resulting in low oil pressure.
The amount of grease applied to the needle-bearings in the rear hub housing may be insufficient.
The brand name and engine model has been omitted from the engine label.