Mitsubishi Truck Canter Tf and CANTER EURO 5 recall: Fuel may leak
The engine fuel return pipe is made of material which may adversely react with chemicals paint etc. These may cause the pipe to swell become loose and leak fuel.
All UK Cars, vans & lorries recalls and safety alerts, newest first, with the hazard, affected models and what to do next. 4,358 listed.
The engine fuel return pipe is made of material which may adversely react with chemicals paint etc. These may cause the pipe to swell become loose and leak fuel.
Affected vehicles may have received the wrong replacement airbag assembly through a previous recall. This replacement air bag may not deploy as intended.
Due to possible loosening of the adjuster lock nut parking brake lever travel may become excessive and the parking brake may not be fully applied. If the vehicle is not parked in accordance with…
The positioning of the starter supply terminal may be incorrect. This may allow it to foul other components and cause a short circuit.
If the retaining ring inside the steering gear has not been fitted correctly the sealing cap would not be fixed axially and might start moving. If the sealing cap has moved the ball return…
The flange nut can seize on the thread of the studs in the fuse box which could mean the terminals do not have the correct torque and may be loose. Electrical cables connected to…
The bolts retaining the offside front leaf spring (or springs) and support bracket(s) may not have been tightened to the correct specification. If a support bracket disconnects this could affect the steering.
Due to an error in the manufacturing process the lower steering shaft universal joint may not have been produced to the correct specification. Under heavy steering forces it is possible for the column shaft…
The tyre may develop an uneven shaped tread area which may affect tyre performance and vehicle handling.
Due to an error in the manufacturing process the lower steering shaft universal joint may not have been produced to the correct specification. Under heavy steering forces it is possible for the column shaft…
The positioning of the starter supply terminal may be incorrect. This may allow it to foul other components and cause a short circuit.
The positioning of the starter supply terminal may be incorrect. This may allow it to foul other components and cause a short circuit.
The propellant mix in certain seatbelt pre-tensioners ignitors may be incorrect. If the front seatbelt pre-tensioners are deployed the lock function of the pre-tensioners cannot be guaranteed.
The airbag initiator may be defective and may prevent the side airbag(s) and/or knee airbag deploying in the event of an accident. In a collision the airbags not deploying could put the occupants at…
The curtain airbag (one or both side) may not deploy in the event of a side impact because the pyrotechnic mix ratio in the ignitor could be incorrect..
If the vehicle is parked on a hill with park selected and the parking brake off or not fully applied the vehicle may not stay stationary. This results in a higher risk of collision.
Due to a fault in the supplier's production process the bolt on the outer side of the seat mechanism on both front seats might not have been fixed properly. In cases where the bolt…
In the event of a colision which deploys the front seat belt retractor pre-tensioner there is a possibility that the insulation material on the inner face of lower 'B' pillar trim could be subjected…
The ignition switch harness connector of some Nissan Micra (K14 models) equipped with a mechanical key may not be correctly locked in position. As a result the connector may disconnect which in an extreme…
The connector on the electric power steering control unit may not be properly sealed against water entry. If water enters the control unit the power steering assistance can be lost. The steering assistance not…
Due to a non-conformity in the supplier's production process the front seat belt pretensioner could malfunction in the event of a collision.
There is a possibility that the bracket holding the air conditioning compressor onto the engine is not properly tightened. As a result there is a risk that this bracket might break during driving. If…
There is a possibility that the relay linked to the electrical circuit of the starter is out of specification. As such the relay might be blocked in a closed position. If this occurs there…
It is possible for the wiring harness in the main switch panel to chafe on a bracket cut-out which could result in a short to earth. If a short circuit occurs it could result…