Fiat Chrysler Automobiles Punto recall: Front seat belt pretensioner may malfunction during deployment
Due to a non-conformity in the supplier's production process the front seat belt pretensioner could malfunction in the event of a collision.
Every new product, food, vehicle, medicine and pet recall in the UK, newest first. Checked against official sources every 15 minutes. 10,512 listed.
Due to a non-conformity in the supplier's production process the front seat belt pretensioner could malfunction in the event of a collision.
The connector on the electric power steering control unit may not be properly sealed against water entry. If water enters the control unit the power steering assistance can be lost. The steering assistance not…
The Combined Braking valve has a rubber washer fitted to a threaded fitment. The rubber washer isn�t suitable for the purpose and has shown signs of allowing hydraulic fluid to pass. If the seal…
The half shaft retaining bolt holes in the rear disc may have an incorrect thread. Retaining bolts may fit but may become loose and fall out. This would allow the half shaft and wheel/hub…
There is a possibility that the relay linked to the electrical circuit of the starter is out of specification. As such the relay might be blocked in a closed position. If this occurs there…
There is a possibility that the bracket holding the air conditioning compressor onto the engine is not properly tightened. As a result there is a risk that this bracket might break during driving. If…
It is possible for the wiring harness in the main switch panel to chafe on a bracket cut-out which could result in a short to earth. If a short circuit occurs it could result…
The rear spring seat bases may develop cracks. Therse could case the seat base(s) to fail and the spriing(s) may detach.
In the event of a stuck throttle cable the ECU will illuminate the check engine light but will not limit engine RPM or vehicle speed.
The steering column UJ pinch bolt may not have been tightened to the correct specification. Under heavy steering loads such as at low speeds movement between UJ and column is possible.
Vibrations can cause the tail / brake light bulb socket to displace and come away from the lamp assembly.
The short hose on the pipe between the turbocharger and the intercoolers could break during the normal use of the vehicle. This could result in loss of performance and cause the check engine light…
The front passenger seatbelt stalk may become deformed. This may weaken the stalk cables and may not act as intended in the event of a collision.
The left and right airbag actuation has been swapped due to an incorrect connector assignment on the wiring harness. In a collision where the airbags are required to deploy the incorrect airbag could be…
Water could enter the front lower suspension ball joint which can cause noise from front suspension and in worst-case failure of lower ball joint. If this occurs directional control could be impaired.
The electrical harness from the Restraints Control Module (RCM) to side crash sensors has been incorrectly orientated. The RCM signal wire for the right hand C Pillar impact sensor is wired to the left…
P053 campaigned vehicles - Brake Disc to Hub Bolts where the front brake pipe from caliper to the brake flexible hose is subsequently showing signs of a chafe condition in some instances it has…
When connected to Jaguar Land Rover�s Symptom Driven Diagnostics (SDD) device and an update is unsuccessfully undertaken the calibration may default to a pre-set condition. In the event of a frontal impact of a…
Torrent Pharma (UK) Ltd is recalling the below batches as a precaution because out of specification results for dissolution were obtained during routine stability testing.
There is a possibility the clamp between the particle filter and the front exhaust pipe is not closed fully due to an unfavourable tolerance pairing.The particle filter could become detached from the exhaust pipe…
Some vehicles may have been manufactured with fuel tanks that do not meet Polaris quality standards. As a result the fuel tank may crack resulting in a fuel leak. A fuel leak in the…
Some vehicles may have been manufactured with wiring harnesses that may short to ground with no circuit protection.
Brake caliper assembly may be incomplete on the models referred to above due to deviations in manufacturing at our supplier. The anti-rattle plates and cotters may be missing. This may lead to problems on…
One or more of the front brake disc retaining screws may loosen. This may be identified by rattling and may affect the brake's efficiency. In extreme instances the brake disc could detach.