Every new product, food, vehicle, medicine and pet recall in the UK, newest first. Checked against official sources every 15 minutes. 10,759 listed.
Expelled transmission fluid may come in contact with the turbocharger or other ignition sources within the engine compartment and lead to a vehicle fire
The Occupant Restraint Control (ORC) module may inadvertently deploy the airbags and/or seat belt pretensioners
All anaesthesia machines with ventilators - using the anaesthesia device in treatment of critical illness, outside its intended use is considered off-label use but may be essential due to ventilator availability.
The rear center head restraint interlock was not welded according to specification.
Pharmaswiss Česka republika s.r.o. (an affiliate of Bausch & Lomb UK Limited) is recalling all unexpired batches of Emerade 300 microgram auto-injectors (also referred to as pens) from patients due to an error in…
A misrouted front brake hose may damage ignition switch wiring.
Incorrect heat shrink tubing on the battery positive cable terminal/harness connected to the fuse board.
The material composition of the gas system high pressure regulator has been found to be outside of specification.
Malfunctions in the heat exchanger for the LNG fuel tank heating may result in very cold liquefied gas reaching components that are not designed to withstand such low temperatures.
Bench seats in the rear may have been installed with the head restraint bars of a different bench seat and/or head restraint variant.
The head restraint padding may separate from the fastening rod.
The Electric Motor Electronics (EME) printed circuit board was not manufactured according to specifications
This product contains sulphur dioxide making it a possible health risk for anyone with a sensitivity to sulphur dioxide and/or sulphites.
This product contains egg, making it a possible health risk for anyone with an allergy or intolerance to egg.
The gear position switch may provide an inaccurate signal.
The engine output shaft bearing may not have had adequate initial lubrication during assembly
The brake pedal mount could break during an emergency stop and cause a total loss of braking capacity.
The steering gear tie rod may not have been assembled with a required spherical washer
A possible material nonconformity of the rear brake line
The rear lower shock absorber mounting bolt might not be tightened to the correct torque setting
The 3rd brake light may not be correctly secured to the vehicle.
The tightening of some rear suspension fixings may not be correct to specification
Possible non-conformity of certain seals in the front wheel arches could lead to water ingress into the passenger compartment.
The tightening and positioning of the seat belt lower bolts may be incorrect.