Every new product, food, vehicle, medicine and pet recall in the UK, newest first. Checked against official sources every 15 minutes. 10,759 listed.
It has been identified that the striker wire on the bonnet lining may not have sufficient support to prove it with the security for its intended purpose. This can lead to incorrect locking of…
The Soft Ware applied during manufacture was incorrect for Medium Duty Engines. All heat temperature sensors are affected and are not functioning. The Heat Sensor function is lost and there is no warning to…
It has been identified that the driver can inadvertently circumvent the correct operating procedure for the closing/opening of the rear plug and slide door. If the door operating sequence has been overridden then when…
Due to exposure of water and dirt intrusion in the engine compartment the alternators may fail prematurely due to seized bearings. In the worst case the alternators could overheat causing an engine compartment fire.
It has been identified that certain internal body joints or fixing may not have been torqued to the correct specification. If not torqued to the correct specification then the joints/fixings may loosen over time.…
It has been identified that the locking nut of the differential pinion may not have been tightened to the correct specification. This will be identified to the driver by noise generated from the differential…
It has been identified that the bonnet striker support may corrode. If this corrosion is not treated there is a possibility the bonnet striker support may fail which will allow the bonnet to open…
On some machines there is a possibility that the main switch lead wire may be damaged by the metal guide located on the steering head pipe. This may expose electrical wires and result in…
Certain driver side airbags the inflator might release shrapnel from the inflator container during deployment which could injure the driver.
It has been identified that the fuel delivery line/pipe may not have been installed to the correct specification. This could result in the incorrect tolerance between the fuel line/pipe and the vehicle under shield…
(Teva UK Limited) Precautionary batch recall of Evacal D3 1500mg/400iu Chewable Tablets after metal contamination was identified in a very small number of tablets
The front suspension wishbones fixing bolts may not be to the correct specification which could lead to a risk of them breaking. This may affetc the driver's ability to control the vehicle.
It has been identified that the airbag/SRS central sensor has been programmed with faulty software. If the vehicle is involved in a frontal or rearward collision then the airbag and seat belt tensioners may…
The passenger air bag inflator may have been incorrectly manufactured/assembled. This may allow leakage of compressed gas and partial inflation of the airbag without a deployment command.
The material of certain front stub axle carriers may not be to specification and under extreme load conditions could crack. In the event of total failure a wheel could separate from the coach affecting…
It has been identified that the Exhaust Gas Recirculation (EGR) valve pipe may fail/break. This will allow hot exhaust gases to escape and potentially damage component in the surrounding area.
The seatbelt mountings on the two seater bench seats may not be correctly tightened. This could cause the seatbelts not fully restrain the passengers and heighten the risk of injury if the vehicle is…
It has been identified that the rear brake shoe lining material may not have been manufactured to the correct specification. This could result in a reduction in brake performance from the rear brakes.
Water ingress may occur in to the harness which can cause corrosion inside the brake light switch. Continued use in this condition can cause a short circuit to occur in the internal circuit of…
If has been identified that a certain batch of tyres may be affected by progressive damage which may cause the tyre tread to detach and adversely affect the control of the vehicle. The separated…
Moisture could enter the micro switches in the seat control unit and lead to intermittent shorting such that the power adjustable driver�s seat may intermittently not operate or may move forwards rearwards up down…
The subject vehicles are equipped with a foot-operated parking brake system containing a parking brake cable and a crank lever which upon activation transmit the force of the parking brake pedal to the brake…
The heated washer jets may have jet heating elements which are not correctly sealed. There is a possibility that poor sealing could lead to corrosion due to water ingress and subsequent overheating of the…
The bonding of the pressure sensors on the axle modulator and proportional relay valve brake components may be incorrect and work loose. Leakage may occur in the area of the pressure sensor and applied…