Every new product, food, vehicle, medicine and pet recall in the UK, newest first. Checked against official sources every 15 minutes. 10,759 listed.
ISOFIX mountings are fixed to a cross member. As a result of vibrations and type of seat used it is possible for the ISOFIX mountings to become insecure and in rare cases break off.
On the affected vehicles the electrical harnesses connecting the heated seats may under certain conditions and over time cause the heated seats to either not work or to operate permanently. This may cause the…
The auxiliary drive belt pulley retainer may fail and cause loss of drive to auxiliary items including the water pump and power steering pump. This may cause an engine management lamp to illuminate engine…
Due to a potential manufacturing defect the gas generator in the driver�s airbag module may not deploy as intended. This may reduce the affectivities of the airbag.
Due to a non conformity during production the passenger's front air bag inflator may rupture during deployment. This may cause metal fragments to pass through the air bag and into the vehicle interior at…
The near side rear seat belt upper mounting bolt may not have been tightened to the correct specification. In the event of an accident the belt may be insecure and not act as intended.
On affected vehicles the turbocharger induction pipe may fail allowing oil to leak. Vehicle users may notice a drop in oil level which should also cause the oil warning lamp to illuminate. This may…
A none conformity in the production process could result in a crack in female metal fitting around the circumference midway between locating pips. This could result in the failure of fitting resulting in separation…
The wheel hub units fitted with FAG bearings may exhibit premature wear in certain trailer applications. Prolonged use in these applications may result in degradation of the bearing grease. Early indicators may include noise…
In the event the heater fan resistor thermal fuse is affected by a combination of several factors there is a possible risk of fire.
On affected vehicles the near side front side air bag may have been incorrectly fitted in its module. As a result it may not deploy as intended during a collision increasing the risk of…
The two horizontal fixing bolts that fix the ball hitch support bar to the tow bar frame may be incorrectly located. This defect can be seen by looking under the rear of the vehicle…
The fuel pressure sensor may not have correctly tightened during assembly. Over time this may affect the seal and allow fuel odour to escape. This could ignite in the presence of an ignition source.
(Special Products Ltd) A batch of Epistatus 10mg in 1ml Oromucosal Solution is being recalled due to the wrong size of neck adaptor in some bottles (EL (16)A/06)
(Hospira UK Limited) Paclitaxel 6mg/ml concentrate for solution for infusion; 100mg in 16.7ml - risk of the exterior of vials contaminated with Methotrexate (EL (16)A/05)
1) The kick starter may not be correctly secure and slip during use. 2) A bolt may have dropped into the air cleaner during assembly. If a bolt is in the air cleaner assembly…
The fuel tubes are not earthed correctly. If an electro static discharge occurs on the fuel tubes it may cause a pin size hole in the fuel tube and a subsequent fuel leak. If…
One or both bolts retaining the passenger air bag may have been omitted during production. As a result the airbag may not deploy as intended during a frontal collision.
On some TRISTOP� actuators the chambers may not have been correctly assembled and the load from power spring and pressure is not fully taken. Under certain circumstances the parking side and the service sides…
The vehicles are equipped with 3-point lap-shoulder belt assemblies in all-three rear seating positions. The inner belt (buckle portion) of each of the rear three seat belt assemblies is secured to the floor of…
There is a risk the passenger airbag mounting bolts are incorrectly installed which can lead to the airbag not correctly deploying. If a heavy front end collision occurs the passenger could sustain additional injury.
Abnormal deployment pressure may lead to rupture of the driver's air bag inflator case. In the event of an inflator rupture metal fragments could be propelled into the passenger compartment.
The connecting rod may fail in early life under certain load conditions. The machines in question are designed to be used off road and as such power request is a factor in the control…
The connecting rod may fail in early life under certain load conditions. The machines in question are designed to be used off road and as such power request is a factor in the control…