Every new product, food, vehicle, medicine and pet recall in the UK, newest first. Checked against official sources every 15 minutes. 10,759 listed.
On the affected vehicles a possible nonconformity of certain seals on the vehicle�s body could lead to water ingress in the passenger compartment. This may affect the operation of the passenger air bag. Unintended…
On the affected vehicles a possible nonconformity of certain seals on the vehicle�s body could lead to water ingress in the passenger compartment. This may affect the operation of the passenger air bag. Unintended…
The bolts retaining the front shock absorber could come loose. This may adversely affect the steering control of the vehicle.
The tightening torque of one of the nuts of the connection between the brake servo unit and the brake pedal may be not correct to specification. This may allow air to enter the servo
On the affected vehicles a possible non-conformity in the positioning of the fuel filler neck seal near the filler cap could cause a fuel leak when completely filling up the tank.
It has been identified that the density of the propellant within the airbag inflator may be insufficient due to inappropriate production and storage conditions of the propellant. In this condition the inflator may abnormally…
The driver side front seat belt pre-tensioner cable could separate during deployment leaving the driver inadequately restrained in a collision which increases the risk of injury.
It has been identified that during production the temperature sensors for the alternator have been installed/located in the wrong position. This can result in the driver not receiving an early warning of the alternator…
Due to an error in the manufacturing process the air bag and/or seat belt pretensioner may not trigger in the event of a collision
It has been identified that the pins within the electric power assisted steering control unit may not have been contact welded correctly. This can result in an open circuit which will lead to a…
Recall of Ergometrine Injections by hameln pharmaceuticals limited because the contents of some ampoules may not comply with the required specification.
The screws retaining the fuel collection pipe(s) may shear under stress. This may allow the pipe(s) to separate from the injector(s) and cause fuel to leak.
Unions on certain brake pipes may not have been tightened to the correct torque. This may allow fluid to escape and affect the braking efficiency.
The front and/or rear axle mounting bolts may not be tightened to the correct specification. The bolts may break and could affect control of the vehicle.
It has been identified that the Central Brake Unit and Rear Axle Modulator units may not function as intended. This can cause a higher braking retardation or quicker braking than anticipated. This can result…
It has been identified that a fuel hose may not have been produced to specification. This can cause a fuel leak which is not rectified could in the worst case scenario result in a…
It has been identified that the side board hinges may fail. This could result in the detachment of the side board whilst the vehicle is in motion.
Due to a manufacturing process deviation the toothed rack of the steering gear might break under extensive force application i.e. when manoeuvring at slow speed.
Certain Citan vehicles may have cracks on the steering column tube due to a manufacturing fault.
There is the possibility of water penetration into the vent hose resulting in water ingress into the vacuum pump over the wire harness and into the relay box. In the worst case a short…
A number of steering spindles may have been fitted that are not to specification. In the worst case the result could be loss of directional control.
It has been identified that the underfloor mounted diesel fuel cooler may not have been manufactured to specification. This can result in fuel leak. The driver will become aware of the issue by either…
The waterproof boots for the throttle cable may not be manufactured to specification. The boots may deteriorate and allow water ingress. The water could freeze in low ambient temperatures causing the throttle not to…
A recess on the inside of the fascia panel may not have been correctly machined . This recess affects the deployment of the front passenger's air bag and it may not deploy as intended.