Every new product, food, vehicle, medicine and pet recall in the UK, newest first. Checked against official sources every 15 minutes. 10,752 listed.
The Hand Brake Valve handle automatic locking function may not maintain the park position. The handle may remain in the lock only temporarily and flip back from the parking position into the driving position…
A tooling problem during manufacture could result in the cylinder head not being to specification. It is possible that the fuel rail could loosen and fuel leaks cannot be ruled out. The customer may…
Affected vehicles may have been built with an incorrect crimping of the turbocharger oil feed pipe connector. This may cause oil leakage which may lead to odours smoke oil specks on the floor or…
If an electrical short occurs in the supply to the rear oxygen sensor the senor will fail but the driver will not see an immediate warning. A MIL warning may display after continued driving…
If the bonnet is not shut correctly on the main bonnet catch and the bonnet then opens to the secondary catch the secondary bonnet catch is not strong enough to hold the bonnet in…
A filter in the Vehicle Stability Assist / Anti lock braking modulator may break and foul one of the one-way check valves in the modulator. If the check valve does not operate correctly the…
Due to vibrations particles inside the airbag control unit may cause a short circuit. This may reset the control module illuminating the airbag warning lamp and prevent the airbag(s) from acting as intended during…
On affected vehicles the driver's air bag inflation device may not conform to specification. As a result may not deploy correctly during an impact.
On affected vehicles the driver's air bag inflation device may not conform to specification. As a result may not deploy correctly during an impact.
Fuel may leak from connections for the fuel tank breather and vent hoses on to the ground. Poor engine running may be experienced accompanied by the engine management warning light. The fuel on the…
Due to a deviation in the manufacturing process the retaining bolt for the right rear seal belt may not have been tightened to the correct specification. In the event of a collision the belt…
There is a possibility that a strut top mounting bearing could be damaged when a high load is applied to the strut such as when the vehicle is driven over a large bump. If…
The brake master cylinder push rod and boot are allowing air to pass into the master cylinder which will gradually extend the movement of the lever until the efficiency of the brake is compromised.
The fuel injectors supply rail could develop a leak over a period of time leading to a drop in fuel pressure which can affect the operation of the stop start system. In some extreme…
The fuel injectors supply rail could develop a leak over a period of time leading to a drop in fuel pressure in the injector supply rail which can affect the operation of the stop…
Due to a misrouted fuel pipe a metal hose clip my chafe against a nylon fuel pipe and may cause a fuel leak
The thread on the swivel pin of the track rod end might not be to specification. Therefore when the nut was tightened onto the thread the correct clamping force may not have been attained.…
The clutch release bearing may not be to specification which can result in difficult clutch and gear use. Additionally the oil pump pressure relief valve may not be to specification which can result in…
The airbag system Occupant Restraint Control (ORC) module may experience a front airbag and/or seatbelt pre-tensioner inadvertent deployment. An inadvertent deployment while driving could distract the driver and cause a crash without warning.
On affected vehicles the incorrect type of bolt may have been supplied during repair work involving the removal of the seat belt mount or belt reel.
The door child locks may disengage without driver knowledge. Though the door remains close it is possible for the door to then be opened from the inside.
The connection of the carbon drive shaft to the engine/transmission flange may not be to specification. Warnings of the development of the concern are: there will be noise malfunctions in the transmission and in…
The exhaust tailpipe variants K7D K7C and K7N can become loose. Variant K7D can fall away from the vehicle leading to a heightened risk of incident for other road users. Where an exhaust gas…
The Automatic Emergency Brake System (AEBS) may in certain traffic situations activate itself