Every new product, food, vehicle, medicine and pet recall in the UK, newest first. Checked against official sources every 15 minutes. 10,592 listed.
If the water drain in the area of the panoramic sunroof is not functioning properly water can seep into the vehicle�s headliner. If sufficient water accumulates the foam adjacent to the pressure cylinder of…
In the event of a crash necessitating deployment of the driver side frontal airbag the front driver side air bag inflator housing may rupture and deploy the airbag abnormally. An inflator rupture could also…
Operations 1) or 2) or operations 1) and 2) could be required: 1) The upper part of the bonnet (the bonnet skin) may detach from the rest of the bonnet due to poor adhesive…
The outer part (skin) of the rear spoiler may detach from the vehicle and /or the pins on the glass tailgate. There would be no warning to the customer. However the possibility of detachment…
Due to a software issue some motocross machines may stall under certain conditions.
The driver can adjust the steering wheel position while the vehicle is in motion. The vehicle may become difficult to control if the driver was to adjust the steering position while driving.
It has been identified that the material used to manufacturer the Pitman arm from is not to the correct specification. This can cause wear of the arm and lead to possible detachment of the…
The printed circuit in the power supply unit may overheat.
When charging the battery externally from the vehicle there is a possibility that the earth provision for some sides of charger enclosure may not function. This is due to the anodising and bonding of…
Manufactured by Roche Diabetes Care – Replacement and update to MDA/2015/029 with new instructions to improve battery lifetime and prevent unexpected pump shut down or rapid battery depletion.
If the machine is intensively used off road there is a potential for the shock-end eyelet on the rear shock absorber to fail.
The Emergency Locking Retractor in the front passenger safety belt assembly may not function correctly. The Emergency Locking Retractors are equipped with a vehicle-sensitive locking mechanism and a webbing-sensitive locking mechanism. The vehicle-sensitive locking…
Foreign particles in the engine coolant can lead to a blockage in the additional coolant pump and cause the pump to overheat.Foreign particles in the coolant can lead to a blockage in the additional…
The front passenger airbag may not function properly due to a deviation in generant mix ratio. In the event of a crash of sufficient severity the front passenger airbag may not deploy when required.…
In certain circumstances the Airbag Control Unit (ACU) may not be correctly configured. This may cause the Supplemental Restraint System (SRS) not to perform as intended in the event of an accident.
The threaded connection for the steering column coupling to the steering rack pinion may not be tightened correctly. Overtime time the connection could loosen and fall out allowing a situation where the steering control…
The threaded connection of the axle stop bracket on the rear axle may not have been tightened to specification. As a result the threaded connection could work loose and allow the bracket to fall…
Biotest UK Ltd is recalling the listed batches due to low level contamination which occurred during manufacture
The front brake caliper might not be fully secure. As a consequence of this the brake caliper can get loose and in the worst case the brake could be lost.
It has been identified the mounting bolts/nuts for the rear underrun device may not have been torqued to the correct specification. This could result in the rear underrun device becoming detached from the vehicle.
A possible nonconformity of an internal component of the starter motor relay could affect the control of the starter motor. This could adversely affect the starting operation and damage the starter motor due to…
A possible nonconformity of an internal component of the starter motor relay could affect the control of the starter motor. This could adversely affect the starting operation and damage the starter motor due to…
On affected machines the Cargo box retaining bracket fasteners may become loose or dislodged under certain conditions.
A deviation in the supplier manufacturing printing process caused a high viscosity in the black print which might lead to a loss of adhesion over vehicle lifetime.