Lexus UX300e recall: Electric Heater Replacement
For affected vehicles there is a possibility that the electric heater could fail when exposed to stress over time causing heater operation to become inoperative.
Car, van, motorbike and caravan safety recalls from the DVSA. 4,885 listed.
For affected vehicles there is a possibility that the electric heater could fail when exposed to stress over time causing heater operation to become inoperative.
For affected vehicles it has been identified that there is potential for movement between the fuel pipe and its retaining clip within the engine bay this movement can potentially lead to wear on the…
Affected roof boxes could be fitted with defective plastic covers on the locking mechanism which may lead to damage to the roof box itself and to the vehicle. In extreme cases the lid of…
On affected vehicles one or both reverse lamps may fail to switch on when the driver selects reverse gear due to a loss of continuity in the rear lamp circuit.
On affected vehicles information on safety instructions (location of emergency exits fire extinguishers and emergency hammers) is missing in the SYNC information screen.
On affected vehicles the correct tightening torque was not reached on some of the rear brake caliper anchor bolts during manufacturing. If one or both caliper mounting bolts are missing or fail the caliper…
The vehicle fixings underneath the passenger front seat may have not been fitted with protection caps.
Certain vehicles may have been fitted with rear brake discs that do not meet design specifications due to incorrect machining during the manufacturing process.
Symptom: The horn does not sound and/or the headlight may not be switched from low beam to high beam.
On affected vehicles there may be defective battery modules which may result in a fire hazard when charging the high-voltage battery.
On affected vehicles the cabling for the crash sensors in the door trim panel was incorrectly assigned which can delay the side airbag trigger in certain crash situations.
On affected vehicles the screw connection of the high-pressure pump was not implemented in accordance with the technical specifications. This can lead to a leak and the possibility of the fuel igniting.
For affected vehicles local overheating may occur at the electrical contacts of the vehicle's engine starter motor. This may cause an increase in current flow resulting in local overheating or risk of thermal event.
For vehicles fitted with a Takata front passenger airbag with a PSPI inflator these vehicles have previously received a like for like replacement front passenger airbag via a previous safety recall campaign.
For affected vehicles there is a risk of head contact with the rear door latch. Due to the sharp edges of the door latch there is a risk of injury when head contact occurs.
For affected vehicles there is a potential defect in the torsion bar within the front seatbelt system.
On affected vehicles the screw connection on the B+ power distributor in the vehicle's boot may have not been properly tightened.
Mercedes-Benz AG has determined that on certain CLA (174 platform) vehicles the software of the driving assistance system might not meet specifications.
Affected vehicles may not show the correct Homologation regulation on the Vehicle Identification (VIN) label.
As part of our continuous quality monitoring we have identified that the vehicle-specific RDF3 (radar front end) installation height value has not been parameterized in Econic 956 Actros 963 Arocs 964 Atego 967 and…
On affected vehicles improper programming of the combination meter display may cause the display to become inoperable and remain blank. This prevents the speedometer from being visible.
For affected vehicles a crack in the gas cookers filling pipe may cause a continuous gas leak when the gas cylinder is opened. The gas -air mixture could be ignited by a heat source…
Due to the programming of the HVAC control ECU software under certain conditions such as a specific failure mode of the electric compressor the HVAC system will enter a failsafe mode that suspends the…
Affected retractors may intermittently fail to auto-lock when a wheelchair is installed at a seating position equipped with an affected retractor. If this should occur a wheelchair may be inadequately restrained and the wheelchair…