Car, van, motorbike and caravan safety recalls from the DVSA. 4,319 listed.
While monitoring vehicles in operation Ford has become aware that a number of Puma Gen-E vehicles may show a mismatch between the Tyre information on the Certificate of Conformity (COC) and Homologation documents and…
According to Ford’s records certain Transit vehicles may not have the remedy for Compliance Recall 21C32 installed correctly but were recorded as having received the repair successfully. Because the correct configuration update may not…
According to Ford’s records certain Mustang vehicles may not have the remedy for Compliance Recall 21C11 installed correctly but were recorded as having received the repair successfully. Because the correct software update may not…
The manufacturer has determined that affected vehicles may be fitted with a front-axle braking system that does not fully comply with the regulatory authority’s requirements.
The affected tyre is more susceptible to cuts and partial penetrations than anticipated when used in rugged and wet environments. These cuts can lead to moisture intrusion and subsequent oxidation of the tyre belt.…
Affected vehicles may experience a right-hand sided front driveshaft failure resulting in a loss of drive.
On certain Peugeot vehicles the Automatic Emergency Braking Assist telltale fails to illuminate if the front camera is blocked. No AEB warning telltale meaning no warning light appears in the instrument cluster. An additional…
On certain Citroen vehicles the Automatic Emergency Braking Assist telltale fails to illuminate if the front camera is blocked. No AEB warning telltale meaning no warning light appears in the instrument cluster. An additional…
On certain Vauxhall Astra L vehicles the Automatic Emergency Braking Assist telltale fails to illuminate if the front camera is blocked. No AEB warning telltale meaning no warning light appears in the instrument cluster.…
On certain DS vehicles the Automatic Emergency Braking Assist telltale fails to illuminate if the front camera is blocked. No AEB warning telltale meaning no warning light appears in the instrument cluster. An additional…
For certain vehicles equipped with second row seats that use recliner assemblies to unlock the seatbacks allow for seatback angle adjustment and locking due to a design change made by the supplier the recliner…
Affected vehicles may exhibit improper headlamp levelling due to an incorrectly assembled Body Height Sensor.
Due to a manufacturing error an ‘inside’ sidewall marking has been printed on the outer sidewall on some tyres. The 'inside' marking should not be printed on directional tyres at all.
On affected vehicles the bolted connection for the push rod between the brake pedal and brake servo may come loose with the risk that it will no longer be possible to stop by using…
There is a combined risk that rear axle hub nuts might have the tightening torque relaxed and the hub might not have been locked looked correctly. In the worst case it could lead the…
On affected tyres the references do not comply with regulatory high-speed requirements which may lead to tread deformation or crown separation when running at high speed.
The rear brake line may contact the Body Control Module (BCM) due to insufficient clearance. Contact between the brake line and the BCM over time could lead to a hole in the brake line…
Mercedes-Benz AG has determined that on certain CLA (174 platform) A-Class (177 platform) and GLA (247 platform) vehicles the bowden cable of the release mechanism of one or more doors might not have been…
On affected motorcycles a fatigue failure of the front brake caliper support may occur after multiple hard or emergency braking. If the support fails front braking will be lost and it will increase the…
The manufacturer has identified there is a risk that the battery cable could chafe against the battery holder bracket and make short circuit.
The manufacturer has determined that affected vehicles have both an earlier version and a later more advanced version of the AEBS control software installed. This co-occurrence may result in different information being displayed on…
As part of our continuous product monitoring we have found that the detection range of the blind spot assist monitoring sensor may be partially covered or restricted by the vehicle body or attachments (e.g.…
Affected vehicles may have both an earlier version and a later more advanced version of the AEBS control software installed. This co-occurrence may result in different information being displayed on the diagnostic dashboard and…
Affected vehicles may have a cylinder block with a missing cooling nozzle. A missing nozzle means the piston may not be adequately cooled causing it to weaken deform or break and leading to sudden…