Car, van, motorbike and caravan safety recalls from the DVSA. 4,799 listed.
On affected vehicles equipped with a Ford Performance Whipple Supercharger Upgrade Kit the updated software may not be able to detect module hardware errors leading to unintended acceleration or unintended vehicle movement increasing the…
Certain vehicles manufactured during a limited production period a high-voltage battery module may not meet quality standards. This may result in significantly reduced autonomy a yellow warning light coming on or a thermal overload…
Affected vehicles may have the incorrect speed limit displayed.
On affected vehicles left-hand rear half shafts were not fully seated into the electric drive assembly which may result in premature wear and a leak. This may eventually lead to a loss of motive…
Affected vehicles may have been built with a potential defect on the instrument panel due to a manufacturing process which could affect passenger airbag operation in the event of a crash.
The vehicle fuel pump may have an internal malfunction which may fail over time. The malfunction indicator light MIL on the vehicle instrument cluster may illuminate when this symptom occurs and if ignored and…
On affected vehicles due to a production nonconformity there may be contact or a reduced clearance between the fuel Particulate Filter pipe and the pole protection cup of the 48V Belt Starter Generator. Under…
The indicator switch may self cancel when activated
Mercedes-Benz AG has determined that on certain Citan model vehicles the clutch pressure plate might not meet specifications.
Some vehicles may face a concern where the instrument cluster panel may reboot during vehicle operation potentially resulting in a blank instrument cluster display screen.
Some vehicles may face a concern where the instrument cluster panel may reboot during vehicle operation potentially resulting in a blank instrument cluster display screen.
For affected vehicles the AdBlue Dosing Module may not have been initialised during the production process. In this condition the AdBlue Dosing Module does not trigger AdBlue injection and therefore NOx emissions are not…
Certain vehicles were built with a potential issue affecting the coolant pump. This issue may lead to an engine failure causing a sudden loss of power without prior warning.
The EU directive for commercial vehicles with the Euro 6 emissions standard stipulates that the NOx sensor signal is regularly checked for plausibility. The IUPR monitor (In Use Performance Ratio) was defined for this…
On affected vehicles a concern has been identified where the third-row lower seat belt anchorage bracket may contain a weld stud of insufficient ISO strength due to material contamination at the supplier. An insufficiently…
On affected vehicles de-bonding of the rear polycarbonate cabin window may occur when driven at high speeds with the windows open.
On affected vehicles due to a Body Control Module (BCM) software weakness an alarm siren may randomly trigger when the vehicle is locked.
On affected vehicles the software repair for previous recall 20S10 may not have been delivered properly and vehicles may exhibit an issue where the transmission lubricant pump gear could fail.
On affected vehicles one of the front suspension bolts may have been overtightened during manufacturer which may cause it to weaken and fracture over time.
On affected motorcycles the indicator wire may have been incorrectly routed during production which may cause a short circuit that can lead to malfunctions in the turn signal system (front and rear) brake lights…
This safety recall involves bolts which fix the left and right side rear seat safety belts to the vehicle body or bolts which fix the rear bench seat configuration backrest locking brackets to the…
A breakage of steering pushrods and steering rods ball studs cannot be ruled out.
The driver airbag inflator housing may rupture due to excessive internal pressure during normal airbag deployment events. This condition is more likely to occur if the vehicle has been exposed to high levels of…
In the event that the airbag is activated excessive internal pressure may cause the inflator body to rupture and metal fragments may pass through the cushion material causing injury to the vehicle occupants and…