Car, van, motorbike and caravan safety recalls from the DVSA. 4,885 listed.
Affected vehicles may have been assembled with contact or with a reduced clearance between the Gasoline Particulate Filter pipe and the pole protection cap of the 48V Belt Starter Generator. There is a possibility…
Affected vehicles may have been assembled with contact or with a reduced clearance between the Gasoline Particulate Filter pipe and the pole protection cap of the 48V Belt Starter Generator. There is a possibility…
On affected vehicles the front camera module calibration may be incorrect which may lead to non-compliance with the speed limit indication system regulatory requirement.
Some vehicles have experienced thermal overload in the high voltage traction battery pack which may present as smoke or fire. Since the installation of protective software field evidence has shown that there remains a…
TGM TGS TGX: The tyres may be manufactured incorrectly. (Michelin)
For certain vehicles and as a preventative measure there is concern involving the locking nuts in the area of the front suspension lower arm ball joints for where loosening of the fixings cannot be…
The Safety Recall relates to the engine starter motor. The fault relates to the RSW22 starter RWT (reinforced water tightness). It was found that with RWT starters an increased abrasion of the magnetic contact…
On affected vehicles the Malfunction Indicator Lamp (MIL) may not function as intended in the Instrument Panel Cluster (IPC). This condition will not affect emissions. However in the event of an emission issue that…
We have recently identified an issue concerning the Electronic Control Unit wiring harness clip in a specific batch of vehicles. Our investigation found that the ECU harness clip was not fully engaged during the…
On affected vehicles insufficient clearance between the wiring harness and transmission housing may lead to damaged wiring or chafing which can cause a short circuit and arcing increasing the risk of fire.
The safety of our customers and the reliability and long-term service life of our models represent our top priority. For this reason Audi conducts programmes to constantly monitor the quality of its products.Extensive analyses…
Affected vehicles may have rear axle joints that were not tightened to the specified torque during manufacturing.
On affected vehicles there is the possibility for detachment of the front high level spoiler.
On affected vehicles there is a risk of electric shock if the AC charging inlet socket (or the power cable to external equipment) is severely damaged and you touch an exposed electrical conducting part…
On affected vehicles under specific environmental conditions a localised high impedance area can occur within the connector leading to high current though small contact areas. This can lead to excessive heat causing the connector…
Škoda Auto has discovered that there is a risk with the Kodiaq model from a limited production period that the edge of the inner frame of the front seats may compromise the integrity of…
Occasion has arisen where the pin securing the hydraulic rear door cylinder has failed owing to corrosion and seizing of the pin causing the door to drop to its vertical position if the door…
Potential malfunction of the rear brake.
During drilling to install the seatbelt mast base plate the drill may penetrate too far and damage the brake hoses under the floor.
On affected vehicles the alloy steel bushes may be missing in all five positions of the alloy wheel. This may result in the wheel nuts falling off or in the worst-case scenario wheel detachment.
On affected vehicles the High Voltage (HV) battery may have been built with a battery pack which contains cells which are susceptible to separator damage which combined with other complex interactions within the cells…
For affected vehicles due to unexpected wear on an internal component the starter motor may not function properly. In some cases this could lead to a non-starting engine or in extreme cases cause a…
For certain vehicles the fuel return pipe was produced in an out-of-specification condition in which certain rubber hose sections may not have been properly vulcanized. This could weaken the connections with other parts and…
On affected vehicles a non-conformity issue with the fuel injection common rail may lead to a loosening of the nut and a potential fuel leak.