Car, van, motorbike and caravan safety recalls from the DVSA. 4,885 listed.
The steering column clock spring may break. This will cause warning messages to illuminate in the instrument cluster but in extreme instances it may cause the driver's airbag to deploy.
There is a possible faulty weld to the gas generator. If the airbag is deployed there is a potential danger to the vehicle occupants by gas generator parts being ejected into the cabin.
Certain riding styles can cause the engine to stall.
The Skid Control ECU may incorrectly interpret signals and may malfunction. This may affect the operation of the Electronic Parking Brake (EPB) although an EPB warning lamp will illuminate and a warning message will…
In certain specific conditions fuel may leak from the low pressure line due to a compatibility issue between the fuel filter and fuel line connector.
On the subject vehicles the resin fuel pump rings located on the top surface of the fuel tank may deteriorate by heat from the engine and exhaust pipes. Over time this deterioration could cause…
The front lower arm ball joint casting may have a crack due to inappropriate manufacturing process being used. In extreme driving conditions this could cause the casting to break and the ball joint to…
The propellant in the front passenger airbag inflator might degrade over time which could cause the inflator body torture in the event the airbag is deployed. This could cause injury to occupants.
The distance between the packing holder and the filler of the fuel tank cap is unsuitable. If the tank cap packing becomes swollen and climbs over the filler sealing failure occurs. When the fuel…
The resistor for the low pressure fuel pump may fail which can cause loss of power and eventually the engine to shut down.
The driver's airbag inflator may rupture due to uncontrolled burning of propellant. As a consequence violent deployment of the airbag may cause injuries to occupants.
Affected vehicles have a 2.0 litre turbocharged diesel engine. There is a possibility that the bolts on the exhaust-side of the turbocharger assembly may not have been correctly tightened during manufacture.
On vehicles fitted with the high power R diesel engine fuel may leak from the fuel feed pipe connection at the high pressure pump. Drivers would feel a lack of power from the engine…
The clutch pedal inhibitor may fail and it will then be possible to start the vehicle in gear without pressing the clutch pedal down.
In the event of heavy breaking such as an emergency stop or an impact with heavy luggage in the boot the rear seats central hinge may break. There would be no prior warning to…
Due to a process deviation in the production front passenger airbag module the connection between detonator and generator may not be sufficient. This may cause the airbag not to deploy as intended.
A connection between the detonator and generator in the front passenger airbag module may not be correctly welded. Therefore the airbag may not be triggered in the event of a collision.
In certain cases a driver may experience sudden loss of power assistance to the steering due to voltage irregularities in the Electro Hydraulic Power Steering (EHPS) system.
A manufacturing defect exists in a production batch of front brake master cylinder components which MV AGUSTA has installed on a series of F4 RR and F4 RC model motorcycles. The defect in the…
On the subject vehicles the tolerances of the teeth on the handbrake sector gear are outside Mazda Corporations design secifications. This reduces engagement between the handbrake sector gear and the ratchet pawl and can…
Because of a manufacturing fault the floating piston in the front brake master cylinder may crack under high stress conditions typical of track use frequent ABS interventions or if a machine is dropped. This…
Because of a manufacturing fault the floating piston in the front brake master cylinder may crack under high stress conditions typical of track use frequent ABS interventions or if a machine is dropped. This…
When combined with a damaged steering column control module clock spring and insufficient grounding of the steering column an electrostatic discharge may lead to an inadvertent deployment of the driver's airbag. Drivers will be…
There is a possibility that the resin weld between the fuel tank and the fuel inlet pipe may be insufficient because the fuel tank and fuel inlet pipe were misaligned during the manufacturing process.