Car, van, motorbike and caravan safety recalls from the DVSA. 4,885 listed.
The lower handlebar holder may have been manufactured with improper painting instruction and thread locking agent may not have been adequately applied to the stud bolt thread of the lower handlebar holder. Due to…
The propellant used in the subject air bag inflators may degrade over time due to heat cycles and exposure to moisture. In the event that the airbag is activated it may overinflate due to…
A number of vehicles specified with automatic transmissions may have been fitted with the incorrect specification rear driveshaft. The incorrect driveshaft length is shorter. The driver may experience underbody noise and/or notice an oil…
Following an accident the forces required for releasing the door may be increased. The cable between the inner door handle and the door lock not being to specification may not be able to withstand…
Under unique driving conditions such as if the accelerator pedal is depressed to the wide open throttle position after driving on a long descent with the use of cruise control there is a possibility…
Due to insufficient strength the front universal joint in the rear front universal joint of the rear prop shaft may fail.
Due to contamination during the production process the fuel filter may leak.
On some of the vehicles affected by this recall the driver's air bag inflator may rupture during deployment. Metal shards may pass through the air bag material and cause injury to occupants.
It is possible that the connection between the B+ cable and the Power Distribution Box can become damaged by wear and heat which is caused by high current flow and high contact resistance. Normally…
A component in the gearbox actuator may not be to the correct specification which may affect gear selection.
A component in the gearbox actuator may not be to the correct specification which may affect gear selection.
It has been established that on certain vehicles fitted with an MDE5 engine they may have been delivered with a lower volume oil pan during production. There is a risk of the sump being…
The rear door child locks may deactivate when a door is slammed. There will be no warning that the child lock has gone from active to inactive.
In certain acceleration cases the automatic gearbox software does not engage the clutch fully and therefore the driver could experience a loss of drive and/or engine judder. The gearbox overheating warning light may also…
Due to inappropriate routing the ventilation line might rub against the battery positive cable which can cause a leakage over time. If leakage occurs fuel vapours will enter the engine compartment causing the risk…
Due to a poor earth connection steering power assistance may by lost.
The bonding of the tailgate spoiler may not conform to specification. This could lead to a lack of adhesion and detachment of the spoiler
It has been identified that the cab wiring harness can come in contact with a support bracket within the cab which can cause chaffing damage. This can result in either the engine cutting out…
It has been identified that the fuel filter/accumulator installed on the engine may crack causing the element to break which will ultimately resulting in fuel leakage. The issue can be identified to the driver…
It has been identified that due to corrosion there maybe a malfunction of the power supply within the Occupant Restraint Control (ORC) module. This could result in either an illuminated airbag warning lamp with…
The driver' s airbag clockspring may ingest dust. This may cause the airbag warning light to illuminate. It may also affect the air bag operation in the event of a collision.
The transaxle wiring harness may have been built with insufficient wire terminal crimp(s). This may cause the transmission to select neutral.
Due to an error in the manufacturing process the air bag and/or seat belt pretensioner may not trigger in the event of a collision
The left and right side window airbags were manufactured with incorrectly manufactured airbag inflator initiators that may not ignite when a deployment voltage is provided to the initiator. As a result vehicles may experience…