Car, van, motorbike and caravan safety recalls from the DVSA. 4,885 listed.
The rear calipers may not have been manufacturer to design specifications. as a result the seals may allow brake fluid to leak. This may affect brake efficiency but the brake fluid level warning light…
The power supply lines for the cab electrical system may not be fastened correctly at the electrical connecting point mounted on the cab firewall and as a result may be loose. A loose cable…
Vehicles fitted with Adaptive LED Headlamps could experience a condition where the loss of a control signal in combination with a software error may cause the headlamps to switch off. There is a risk…
The engine may be difficult to start and / or the engine may stall without warning from fuel starvation and will be impossible to restart. When fuel is present in the fuel pump it…
The locking forces of the maintenance flap may not be to specification. At high speed and in combination with strong gusts of wind the plastic maintenance flap may detach from the vehicle and may…
A lock nut on a rear suspension tie rod may not have been manufactured to the correct specification. It may not act as intended even tightened to specification. It is unlikely the rod will…
The wheel bolts may not have been tightened correctly at the factory. If the bolts come loose the directional control of the machine may be compromised.
The software for the RSC is not to the correct specification and is unable to detect and mitigate a potential vehicle roll over condition. All other Stability Control Systems including Dynamic Stability Control (DSC)…
The drag link may not have been manufactured to the correct specification. There may be clearance between the draglink nut and the draglink arm which could potentially result in loss of steering control.
The subject vehicle could unexpectedly lose drive and coast to a halt with no motive power due to a software issue in the powertrain control unit. In certain circumstances it is possible that the…
The vibrations that occur during normal running of the motorcycle can turn the ignition off. If this occurs all power from the engine will be lost possibly putting the rider in danger.
The front bevel box fitted to the engine assembly has not been manufactured to specification. The deficiency can lead to oil starvation to the input gear shaft could result in 6th gear input becoming…
The left front brake caliper housing may have been cast from an incorrect material. Under extreme brake application the left front brake caliper housing may rupture and affect braking efficiency.
In extreme and hard driving conditions it is possible for the rear tie rod fixing bolt to become loose which can ultimately result in loss of vehicle control.
Due to an error in the size of the slots on rear wheel rim hub it is possible that the rear wheel rim might have been installed in the wrong way with the 4…
Under certain circumstances a dimensional error on the subject aftermarket front brake levers may cause the brake lever blade to contact the handlebar grip before maximum brake performance is achieved. This condition if present…
The tow bar and whatever is being towed may become detached from the vehicle because a number of mounting points are missing from the tow bar. A loose trailer without directional control and possibly…
A clutch component might fail and cause the rear wheel to lock during motorcycle use. The likely cause is high and repeated stresses on the clutch assembly after a heavy use of the motorcycle…
ISOFIX mountings are fixed to a cross member. As a result of vibrations and type of seat used it is possible for the ISOFIX mountings to become insecure and in rare cases break off.
The auxiliary drive belt pulley retainer may fail and cause loss of drive to auxiliary items including the water pump and power steering pump. This may cause an engine management lamp to illuminate engine…
On the affected vehicles the electrical harnesses connecting the heated seats may under certain conditions and over time cause the heated seats to either not work or to operate permanently. This may cause the…
Due to a potential manufacturing defect the gas generator in the driver�s airbag module may not deploy as intended. This may reduce the affectivities of the airbag.
On affected vehicles the turbocharger induction pipe may fail allowing oil to leak. Vehicle users may notice a drop in oil level which should also cause the oil warning lamp to illuminate. This may…
The near side rear seat belt upper mounting bolt may not have been tightened to the correct specification. In the event of an accident the belt may be insecure and not act as intended.