Car, van, motorbike and caravan safety recalls from the DVSA. 4,885 listed.
On the affected vehicles the operation of the brake vacuum pump may be affected by material detaching from the timing belt caused by the ageing of the engine oil.
On the affected vehicles the operation of the brake vacuum pump may be affected by material detaching from the timing belt caused by the ageing of the engine oil.
On eligible units and models an improper control programme in the multi-function meter may exist.
The plunger in the camshaft-chain tensioner can lock up during usage due to deterioration of internal parts.
A fuel leak at the fuel pump outlet connector on the fuel tank may occur.
On affected vehicles the connection of the B-pilar trim to the structural inlay may not meet specifications. �
A degrade of emissions control components may occur.
Some vehicles may have been equipped with an incorrectly positioned fuel pipe.
Some braking and suspension components may not have been tightened to the correct torque during assembly.
Some vehicles have an inappropriate design and material on the check valve of brake vacuum pump.
Some vehicles may have been equipped with an incorrectly positioned fuel pipe.
Some vehicles may have been equipped with an incorrectly positioned fuel pipe.�
Some Kuga vehicles with a panoramic roof may have a fixed glass panel with poor adhesion to the roof frame assembly. As a result there is a possibility that the fixed glass panel could…
There is a risk the automatic gear shift lever could be moved out of Park without the foot brake pedal being applied. If this occurs and should the parking brake not be activated a…
Certain bikes are illegal for use on the road as they are not type approved to the required standards.
In certain situations the cycle carrier can fail which could potentially lead to a bicycle becoming detached from the vehicle. Manufacturer advice is that the cycle carrier should NOT USED until the required rectification…
The brake performance of affected models can reduce due to thermal deformation of the tractors� brake discs/plates particularly when operated on an incline or decline.
On certain righthand drive VClass (447 platform) vehicles the routing of the interior wiring harness in the area of the centre console might not meet specifications.
The installed 15 A fuse protecting the DRL (Daytime Running Lights) has an amperage rating which is too large.
A wiring harness may have been improperly assembled by the supplier and wires may contact the brake line and/or vehicle frame.
One or both of the front panoramic sunroof drain tubes may be cracked this could result in water entering the interior of the vehicle. The wiring harness and body control unit (BCP) can be…
In some cases the free gearwheels 6th gear that were installed do not meet the specifications. For this reason extended full load operation in 6th gear can cause increased wear of thegearshift forks. In…
The wheel bolts may have been tightened with insufficient tightening torque and incompatible wheel bolts may have been used.
The clamping force on the pinion bearing may have been too low when fitting the nut to the end yoke.