VW Id Buzz recall: Bracket for air conditioning rear
On affected vehicles brackets with sharp edges were fitted to the rear air conditioning block. In the event of an accident when the side airbags are triggered there is a risk of damage from…
Car, van, motorbike and caravan safety recalls from the DVSA. 4,885 listed.
On affected vehicles brackets with sharp edges were fitted to the rear air conditioning block. In the event of an accident when the side airbags are triggered there is a risk of damage from…
On affected motorcycles the crankcase fastening bolts may have been over-tightened during production. This can cause seizure of the crankshaft main bearing leading to abnormal noise and engine stalling.
On Touareg vehicles with hybrid drive systems and of a limited production period there may be deviations on the high-voltage battery system. A measure is necessary because on individual battery modules deviations with important…
Some brake discs within the aforementioned article numbers have not been manufactured in accordance with specifications. These defective brake discs pose a risk that the vehicle may skid when braking or experience a longer…
On affected vehicles equipped with a combination meter system where various information is displayed (warning and indicator lights vehicle gauges messages etc.) due to improper programming the memory device within the combination meter can…
Mercedes-Benz AG has determined that on certain CLA (174 platform) vehicles the belt buckles of the driver and passenger seats might not meet specifications respectively.
Mercedes-Benz AG has determined that on certain CLA (174 platform) vehicles the routing of a window-airbag wiring harness in the area of the D-pillar might not meet specifications.
Mercedes-Benz AG has determined that on certain CLA (174 platform) vehicles the software of the driving assistance system might not meet specifications.
Mercedes-Benz AG has determined that on certain CLA (174 platform) vehicles the composition of the window-airbag fabric might not meet specifications.
On affected vehicles there is a requirement to update the Engine Control Module (ECM) calibration due to a production non-conformity and not fulfilling emission regulatory requirements.
Affected vehicles may experience corrosion that can weaken or detach the seatbelt anchor pretensioner cables for both front seats. A corroded pretensioner cable may not adequately restrain an occupant in a crash.
Affected vehicles may have the Headlamp Height Level sensor fitted with incorrect orientation causing the Headlamp beam to be aimed too low and does not adjust as it should.
A quality check has revealed a potential issue with the steering gear software program which monitors the function of two sensors and compares the signals. In the vehicles concerned due to an error in…
The software repair for a previous recall may not have been properly delivered to the vehicle. The underlying noncompliance specified in the recall still exists and customers will not receive a warning if there…
On a number of Fiat 600 vehicles due to a production nonconformity there is a requirement to inspect the brake pedal bracket connection and if necessary perform a rework to eliminate any potential risk…
On a number of Alfa Romeo Junior vehicles due to a production nonconformity there is a requirement to inspect the brake pedal bracket connection and if necessary perform a rework to eliminate any potential…
On a number of Abarth 600 vehicles due to a production nonconformity there is a requirement to inspect the brake pedal bracket connection and if necessary perform a rework to eliminate any potential risk…
The affected tyres may have been manufactured with irregular geometry in the sidewall (shoulder) area of the tyre. Under certain circumstances this irregular geometry may lead to a sidewall crack at the shoulder area…
For affected machines there is a potential defect concerning some welds on the frame which may have insufficient strength. Riding on uneven road surfaces or through potholes may result in cracks forming causing the…
For certain vehicles the end-stop breaking force of the accelerator pedal is lower than the intended technical specification. This may lead to a rupture of the accelerator pedal assembly if the pedal is pressed…
For certain vehicles reprogramming of the injection computer is required. Without this software update it could lead to breakdown or the vehicle failing to start.
On affected vehicles the front left seat bolts may not have been torqued according to specification which could reduce the occupant protection in an impact.
Affected vehicles may have High Voltage (HV) battery bolts that are loose which over time could lead to a loss of motive power. .
The front fork steer tube can fatigue prematurely and crack break or separate during use. As a result the rider may lose control of their bike posing a fall and injury hazard.