Car, van, motorbike and caravan safety recalls from the DVSA. 4,885 listed.
Some vehicles may have been manufactured with an incorrect driver seat wiring harness layout which can cause the seat wiring harness to rub against metal points on the seat/seat frame assembly through normal seat…
The fixed fork tube can suffer preliminary damage due to unusual incidents with momentary high stress without the user noticing the damage. Through longer usage with high stress the pressed in seal plug can…
Due to a faulty connection parts of the pyrotechnical system could enter the vehicles cabin during deployment.
Due to a software error the brake lights may not function during an emergency operation of the electronic parking brake. The normal foundation brake lights will still function as intended.
The engine oil cooler feed pipe may disconnect and leak oil. This may reach the front brakes and affect the braking efficiency.
The front axle housing could have sustained material damage during the production process leading to a potential to fail without warning. An axle break can lead to wheel loss and the vehicle may no…
The positioning of the starter motor supply terminal may not conform to specification. Contact with a neighbouring component could cause a short circuit.
The positioning of the starter motor supply terminal may not conform to specification. Contact with a neighbouring component could cause a short circuit.
The Internal Combustion Engine may not operate correctly. DTC�s will be generated the engine-warning lamp will illuminate and the combination meter will display a message. In the worst case the internal combustion engine will…
There may be a fuel leak from the fuel pipe connecting the fuel filter to the high-pressure pump. Drivers would feel a lack of power form the engine and a possible smell of diesel.…
An oil line may not have been correctly clamped which may allow oil to leak.
In the event that the airbag is activated excessive internal pressure may cause the inflator body to rupture and metal fragments may pass through the cushion material causing injury to the vehicle occupants and…
A component within the left-hand curtain airbag may not conform to specification and the air bag may not deploy correctly.
A component within the right-hand curtain airbag may not conform to specification and the air bag may not deploy correctly.
A faulty air conditioning high pressure hose may have been fitted. In the event of a frontal collision there could be a leak of polluting and flammable gas.
On vehicles with ABS/ESC the earth connection may be interrupted. This may cause failure of the ABS/ESC system
The airbag manufacturer have informed Nissan of a potential concern with propellant degradation of Front Passenger Airbag fitted with Smokeless Passenger Inflator (SPI). It has been confirmed that this degradation is a function of…
The driver�s airbag was manufactured with an incorrectly manufactured airbag inflator initiator that may not ignite when a deployment voltage is provided to the initiator. As a result vehicles may experience a �non-deployment� of…
The driver�s airbag was manufactured with an incorrectly manufactured airbag inflator initiator that may not ignite when a deployment voltage is provided to the initiator. As a result vehicles may experience a �non-deployment� of…
As part of a software update the stored adjustment settings for the automatic clutch were not deleted and re-taught. These stored settings are incompatible with the updated software and can result in incorrect operation…
A hydraulic connector may fail and cause a transmission oil leak. This may have an adverse effect on gear selection.
A hydraulic connector may fail and cause a transmission oil leak. This may have an adverse effect on gear selection.
Due to a faulty connection part of the pyrotechnical system could become dislodged on deployment in an accident and enter the vehicle interior putting the occupants at risk of injury. On affected vehicles.
The flange nut can seize on the thread of the studs in the fuse box which could mean the terminals do not have the correct torque and may be loose. This could cause arcing.