Car, van, motorbike and caravan safety recalls from the DVSA. 4,886 listed.
For affected machines the installation of certain accessory kits (Fairing Lowers and/or Inverted Forks) fitted on certain Model Year 2023 – 2025 Touring and CVO Touring machines may take the vehicle out of compliance.
Affected vehicles may face a front seat belt pretensioner malfunction in the event of a crash due to the inversion of command wires in the Airbag ECU connector.
Rear and/or front side reflectors fitted to the motorcycle may not meet the reflective performance requirements as per initial design.
On affected vehicles the front seat belt may have been accidentally damaged during the parts preparation for assembly.
Rear and / or Side reflector fitted in the motorcycle may not meet the reflective performance requirements as per the safety standards.
Actros 963 and Arocs 964 models depending on the model designation up to two screws per installed axle bearing bracket may be missing. The axle bearing bracket guides the rear axle in the longitudinal…
Mercedes-Benz has determined that on certain AMG GT Coupe (192 platform)S-Class (223 platform) SL (232 platform) GLC (254 platform) and AMG GT 4-doorsCoupe (290 platform) vehicles with hybrid powertrain the processor of the control…
When the turn signal is switched off after operating the turn signal or hazard light more than 5 minutes the upper part of Daytime Running Light (DRL) stays off. The DRL will subsequently not…
Due to an error by a plant assembly worker some of the seat mounting bolts may be missing in the subject vehicles. Seats with missing seat mounting bolts may not properly restrain an occupant…
On affected vehicles the low-pressure fuel pipe could come in to contact with one of the ignition coil screws. This could lead to fuel pipe damage over time resulting in a fuel leak.
On affected vehicles the low-pressure fuel pipe could come in to contact with one of the ignition coil screws. This could lead to fuel pipe damage over time resulting in a fuel leak.
On affected vehicles due to decrease of the grease amount in the worm wheel gear meshing area of the EPS gear box during use the sliding resistance at the meshing area increases and the…
On affected motorcycles the clutch release shaft was not properly welded to the lever due to an improper manufacturing process.
On a small percentage of affected vehicles upon vehicle power up the car computer board may experience a short resulting in the loss of rear view camera functionality .
On affected tyres there is the potential for the occurrence of a circumferential crack in the bead area which could present an increased risk of rapid tyre pressure loss.
On affected vehicles the bonding strength of the wheelchair ramp to hinge plate may not meet requirements. A de-bonded ramp could collapse without warning while in use.
On affected vehicles the rear brake hoses may not have been crimped correctly during production.
On affected vehicles incorrect data has been entered on the registration document and correspondingly the Certificate of Conformity (CoC).
On affected vehicles incorrect data has been entered on the registration document and correspondingly the Certificate of Conformity (CoC).
Hyundai has identified that the alternator electrical wiring harness may be incorrectly tightened within the engine bay junction box which may result in a high electrical resistance.
On affected vehicles the High Voltage (HV) Battery may have a manufacturing defect which could cause the battery cells to overheat when the HV Battery is fully charged. In a worst-case scenario there is…
Affected vehicles may face an error in the Battery Monitoring Unit software.
Affected vehicles may face an error in the Battery Monitoring Unit software.
Affected vehicles may face an error in the Battery Monitoring Unit software.