Car, van, motorbike and caravan safety recalls from the DVSA. 4,885 listed.
On affected vehicles minor impact to the lower front bumper cover could break the mounting tabs resulting in the lower bumper cover the engine under cover and the front wheel arch liners detaching from…
The passenger air bag may not have been correctly secured.
Affected vehicles have bike rack fixings that may fail during use resulting in the detachment from the vehicle of the bike rack and any bikes being carried at the time.
On affected vehicles the fuel tank is not to specification due to a deviation in the manufacturing process which could lead to a potential risk of fuel seepage.
Affected vehicles may not have the correct installation and tightening between the suspension control arm and the steering knuckle joint.This may possibly result in the control arm bolt becoming detached from the knuckle seat…
On affected vehicles the tailpipe emission standards are exceeded due to a loss of catalyst CO/NOx conversion efficiency as a result of the catalyst operating at high temperatures.
On affected vehicles the left brake hose on the rear axle might not have been installed according to specifications.
Affected vehicles are fitted with a high-pressure fuel pump which over time could develop a crack which could lead to a fuel leak and a risk of a vehicle fire.�
Affected vehicles are fitted with a high-pressure fuel pump which over time could develop a crack which could lead to a fuel leak and a risk of a vehicle fire.
On affected vehicles the rear coil springs may not have been installed correctly which may lead to one or both of them detaching from the vehicle while driving.
The nut supplied with the track rod end is different to the nut that is used on the vehicle. If the incorrect nut supplied was used this would result in the track rod end…
On affected vehicles the steering wheel ground connection may have been insufficiently fastened during production which may result in the system detecting the hands are on the steering wheel even though they are not��
Certain vehicles are equipped with tires which do not meet the Rolling Road Resistance as required to support emissions and Co2 requirements.
On affected vehicles if the Auxiliary charge (3 pin) cable is used with household extension leads and/or substandard domestic wall sockets for an extended period there is a possibility of the auxiliary charge cable…
Affected vehicles have an inappropriate design of the control circuit of the rear combination lamp and the voltage applied to the LEDs in the rear combination lamp could be reduced in certain circumstances. If…
Certain engines may have been produced with conditions that can cause premature wear of the connecting rod bearings
On affected vehicles the socket for the front towing device might not meet specifications.
Ranger vehicles where the High Pressure (HP) Pipes connecting with the Fuel Pump may not have been correctly tightened to specifications.� Incorrectly tightened HP Pipe joints/nuts may loosen over time resulting in a fuel…
A weld seam on the outer backrest frame of the front seats may not have been made correctly.�
Rear brake pedal travel may increase prior to feeling the brake engage.
On affected vehicles the side airbag installed in bucket seats may be activated unnecessarily.
On affected motorcycles the T-box rubber support ring could break allowing the T-Box to drop into a position that could affect the steering.
On affected vehicles the engine as well as the electric motor may shut down to failsafe mode with little or even no warning.
On certain vehicles the engine may fail to start while driving or when at a stop.