Every new product, food, vehicle, medicine and pet recall in the UK, newest first. Checked against official sources every 15 minutes. 10,759 listed.
There is a possibility that water could enter the cabin through the panels separating the cabin and the engine compartment. If this occurs water could reach and affect some electrical components such as the…
A spline on the universal joint of the steering spindle has been machined incorrectly. It is possible for the steering column to slip on the spline so that directional control is adversely affected.
It has been identified that the side board/tail board hinges may fail. This could result in the detachment of the side board whilst the vehicle is in motion.
The passenger air bag may not deploy as intended
A roof side rail air bag may not deploy as intended
The driver's air bag may not deploy as intended
A front seat side air bag may not deploy as intended
The longitudinal control arm of the rear axle may not be correctly fastened. This may cause the arm to break and/or detach.
It has been identified that the socket protective device on the inverter may be defective. This can result in the inverter socket not be protected by the residual current circuit breaker against residual current.…
The cable lug of the ground line on the engine�s mounting bolt may break. If the ground connection is interrupted completely the vehicle can become completely de-energised which can lead to a sudden and…
It has been identified that the lever used to select the drive range on the steering column switch module may become inoperative due to possible damage of a circuit board. In the event of…
The ball joint securing the upper arm to the steering knuckle may not have been tightened to the correct torque.
The door striker pins could be damaged/deformed to a position where it is possible for the doors/s to open when the vehicle is travelling at high speed.
It has been identified there is a possibility that during production the split pin for the brake pedal cross shaft may not have been correctly installed. This could result in the reduction of braking…
It has been identified that the front passenger seat occupancy weight sensing system control unit may have bee incorrectly installed during assembly. If the passenger seat is placed in the rear/lower position range then…
The wiring to the front windscreen washers may not have been correctly routed. This may cause a short circuit and render the wipers in operative.
It has been identified that the battery positive and negative cables may chaff on a bracket/area between the engine and the gearbox. If this occurs then it can result in a short circuit with…
The retaining bolts used to assemble the Inflatable Curtain may be broken and offer less protection in the event of an incident.
The ignition module which triggers the front seat airbag may not deploy in the event of an impact. There is no indication to the driver the unit is faulty.
The ignition module which triggers the front seat airbag may not deploy in the event of an impact. There is no indication to the driver the unit is faulty.
In sub-zero weather conditions the front windscreen blades arms may become frozen to the screen. In extreme circumstances when the wipers are activated the wiper arm linkage may weaken detach or bend. Should the…
Due to an error in the production process the engine camshaft may break.
The drive chain connecting link is not manufactured to specification which can lead to premature failure of the connecting link possible consequential damage and loss of drive.
The transmission could unexpectedly switch to the N position due to a nonconformity in the transmission wiring assembly process.