Peugeot EXPERT 4 and Traveller recall: Starter motor supply wiring harness may become damaged
The positioning of the starter supply terminal may be incorrect. This may allow it to foul other components and cause a short circuit.
Car, van, motorbike and caravan safety recalls from the DVSA. 4,885 listed.
The positioning of the starter supply terminal may be incorrect. This may allow it to foul other components and cause a short circuit.
On affected machines fuel may leak from the fuel tap when it is operated.
On affected machines carburettor float may stick causing a fuel leak.
The propellant mix in certain seatbelt pre-tensioners ignitors may be incorrect. If the front seatbelt pre-tensioners are deployed the lock function of the pre-tensioners cannot be guaranteed.
The airbag initiator may be defective and may prevent the side airbag(s) and/or knee airbag deploying in the event of an accident. In a collision the airbags not deploying could put the occupants at…
The clip-on handlebar is susceptible to Stress Corrosion Cracking. This can cause the part to fail during use and could affect control of the machine. The manufacturer recommends to immediately STOP using the clip-ons
The curtain airbag (one or both side) may not deploy in the event of a side impact because the pyrotechnic mix ratio in the ignitor could be incorrect..
If the vehicle is parked on a hill with park selected and the parking brake off or not fully applied the vehicle may not stay stationary. This results in a higher risk of collision.
Due to a fault in the supplier's production process the bolt on the outer side of the seat mechanism on both front seats might not have been fixed properly. In cases where the bolt…
In the event of a colision which deploys the front seat belt retractor pre-tensioner there is a possibility that the insulation material on the inner face of lower 'B' pillar trim could be subjected…
The ignition switch harness connector of some Nissan Micra (K14 models) equipped with a mechanical key may not be correctly locked in position. As a result the connector may disconnect which in an extreme…
The connector on the electric power steering control unit may not be properly sealed against water entry. If water enters the control unit the power steering assistance can be lost. The steering assistance not…
Due to a non-conformity in the supplier's production process the front seat belt pretensioner could malfunction in the event of a collision.
The half shaft retaining bolt holes in the rear disc may have an incorrect thread. Retaining bolts may fit but may become loose and fall out. This would allow the half shaft and wheel/hub…
The Combined Braking valve has a rubber washer fitted to a threaded fitment. The rubber washer isn�t suitable for the purpose and has shown signs of allowing hydraulic fluid to pass. If the seal…
There is a possibility that the bracket holding the air conditioning compressor onto the engine is not properly tightened. As a result there is a risk that this bracket might break during driving. If…
There is a possibility that the relay linked to the electrical circuit of the starter is out of specification. As such the relay might be blocked in a closed position. If this occurs there…
It is possible for the wiring harness in the main switch panel to chafe on a bracket cut-out which could result in a short to earth. If a short circuit occurs it could result…
The rear spring seat bases may develop cracks. Therse could case the seat base(s) to fail and the spriing(s) may detach.
In the event of a stuck throttle cable the ECU will illuminate the check engine light but will not limit engine RPM or vehicle speed.
The steering column UJ pinch bolt may not have been tightened to the correct specification. Under heavy steering loads such as at low speeds movement between UJ and column is possible.
Vibrations can cause the tail / brake light bulb socket to displace and come away from the lamp assembly.
The short hose on the pipe between the turbocharger and the intercoolers could break during the normal use of the vehicle. This could result in loss of performance and cause the check engine light…
The front passenger seatbelt stalk may become deformed. This may weaken the stalk cables and may not act as intended in the event of a collision.